Infiniti I30 (A33). Manual — part 87
AAT426
5.
Install forward clutch hub on rear internal gear.
I
Check operation of forward one-way clutch.
Hold rear internal gear and turn forward clutch hub.
Check forward clutch hub for correct locking and unlock-
ing directions.
I
If not as shown in illustration, check installation direction
of forward one-way clutch.
SAT157F
6.
Install thrust washer and overrun clutch hub.
I
Apply petroleum jelly to thrust washer.
I
Align hooks of thrust washer with holes of overrun clutch
hub.
I
Align projections of rear internal gear with holes of over-
run clutch hub.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Rear Internal Gear, Forward Clutch Hub and Overrun Clutch Hub (Cont’d)
AT-345
Output Shaft, Idler Gear, Reduction Pinion Gear
and Bearing Retainer
COMPONENTS
NHAT0165
SAT291K
SAT164F
DISASSEMBLY
NHAT0166
1.
Remove seal rings from output shaft and bearing retainer.
REPAIR FOR COMPONENT PARTS
Output Shaft, Idler Gear, Reduction Pinion Gear and Bearing Retainer
AT-346
SAT165F
2.
Remove output shaft bearing with screwdrivers.
I
Always replace bearing with a new one when removed.
I
Do not damage output shaft.
SAT166F
3.
Remove snap ring from bearing retainer.
SAT167F
4.
Remove needle bearing from bearing retainer.
SAT168F
5.
Remove idler gear bearing inner race from idler gear.
SAT859DC
6.
Remove idler gear bearing outer race from transmission case.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Output Shaft, Idler Gear, Reduction Pinion Gear and Bearing Retainer (Cont’d)
AT-347
SAT169F
7.
Press out reduction pinion gear bearing inner race from reduc-
tion pinion gear.
SAT319K
8.
Remove reduction pinion gear bearing outer race from trans-
mission case.
INSPECTION
NHAT0167
Output Shaft, Idler Gear and Reduction Pinion Gear
NHAT0167S01
I
Check shafts for cracks, wear or bending.
I
Check gears for wear, chips and cracks.
SPD715
Bearing
NHAT0167S02
I
Make sure bearings roll freely and are free from noise, cracks,
pitting or wear.
I
When replacing taper roller bearing, replace outer and
inner race as a set.
SAT171F
Seal Ring Clearance
NHAT0167S03
I
Install new seal rings to output shaft.
I
Measure clearance between seal ring and ring groove of out-
put shaft.
Standard clearance:
0.10 - 0.25 mm (0.0039 - 0.0098 in)
Allowable limit:
0.25 mm (0.0098 in)
I
If not within allowable limit, replace output shaft.
I
Install new seal rings to bearing retainer.
REPAIR FOR COMPONENT PARTS
Output Shaft, Idler Gear, Reduction Pinion Gear and Bearing Retainer (Cont’d)
AT-348
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст