Infiniti I30 (A33). Manual — part 113
SBR646
SBR868C
8.
Insert piston seal into groove on cylinder body.
9.
With piston boot fitted to piston, insert piston boot into groove
on cylinder body and fit piston by turning it clockwise with long
nose pilers, or suitable tool.
SBR027D
10. Fit toggle lever, return spring and cable guide.
SBR306E
11. Adjust the piston to the right angle as shown in the figure.
SBR307E
Installation
NHBR0043
CAUTION:
I
Refill with new brake fluid “DOT 3”.
I
Never reuse drained brake fluid.
1.
Install caliper assembly.
I
As shown in the figure, align the piston’s concave to the pad’s
convex, then install the cylinder body to the torque member.
2.
Install brake hose to caliper securely.
3.
Install all parts and secure all bolts.
4.
Bleed air. Refer to “Bleeding Brake System”, BR-9.
GI
MA
EM
LC
EC
FE
AT
AX
SU
ST
RS
BT
HA
SC
EL
IDX
REAR DISC BRAKE
Assembly (Cont’d)
BR-35
SBR559E
CAUTION:
The pad retainer is built so the pad returns to its original
position. Be careful to install the pad so the pad-return lever
is against the inner side of the pad, as shown in the left fig-
ure.
REAR DISC BRAKE
Installation (Cont’d)
BR-36
Components
NHBR0044
SBR584E
SBR025D
Removal and Installation
NHBR0045
1.
To remove parking brake cable, first remove center console.
2.
To remove parking brake pedal, remove lower instrument
panel on driver side.
3.
Disconnect warning switch connector.
4.
Remove bolts, slacken off and remove adjusting nut.
5.
Remove lock plate and disconnect cable.
Inspection
NHBR0046
1.
Check parking brake pedal assembly for wear or other dam-
age. Replace if necessary.
2.
Check wires for discontinuity or deterioration. Replace if nec-
essary.
3.
Check warning lamp and switch. Replace if necessary.
4.
Check parts at each connecting portion and, if found deformed
or damaged, replace.
GI
MA
EM
LC
EC
FE
AT
AX
SU
ST
RS
BT
HA
SC
EL
IDX
PARKING BRAKE CONTROL
Components
BR-37
SBR264B
Adjustment
=NHBR0047
Pay attention to the following points after adjustment.
1)
There is no drag when control lever is being released.
2)
Be sure that toggle lever returns to stopper when parking brake
pedal is released.
1.
Loosen parking brake cable.
2.
Depress brake pedal fully more than five times.
3.
Operate control pedal 10 times or more with a full stroke [203.5
mm (8.01 in)].
4.
Adjust control lever or pedal by turning adjusting nut.
5.
Depress pedal with specified amount of force. Check lever
stroke and ensure smooth operation.
Number of notches:
3 - 4 [196 N (20 kg, 44 lb)]
6.
Bend warning lamp switch plate. Warning lamp should come
on when lever is depressed “A” notches. It should go off when
the lever is fully released.
Number of “A” notches: 1
PARKING BRAKE CONTROL
Adjustment
BR-38
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст