Infiniti I30 (A33). Manual — part 166
SBT876
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
EXTERIOR
Removal and Installation (Cont’d)
BT-45
Removal and Installation
NHBT0018
I
When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage.
★
For Wiring Diagram, refer to EL-265, “POWER SEAT” for details.
CAUTION:
I
Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait
at least 3 minutes.
I
When checking the power seat circuit for continuity using a circuit tester, do not confuse its con-
nector with the side air bag module connector. Such an error may cause the air bag to deploy.
I
Do not drop, tilt, or bump the side air bag module installed in the seat. Always handle it with care.
FRONT SEAT
Removal and Installation
BT-46
POWER SEAT
NHBT0018S01
SBT877
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
FRONT SEAT
Removal and Installation (Cont’d)
BT-47
HEATED SEAT
NHBT0018S03
I
When handling seat, be extremely careful not to scratch heating unit.
I
To replace heating unit, seat trim and pad should be separated.
I
Do not use any organic solvent, such as thinner, benzene, alcohol, gasoline, etc. to clean trims.
★
For Wiring Diagram, refer to EL-268, “HEATED SEAT” for details.
SBT887
Active Head Restraint
NHBT0032
The active head restraint system is designed so that the headrest
instantaneously moves towards the front upper direction by utiliz-
ing the force at the seatback during a rear-end collision.
As a result, the occupant’s head is protected from being
overextended, reducing the chance for neck injury as much as
possible.
Seat with active head restraint have the labels shown in figures at
left.
SBT888
OPERATION OUTLINE
NHBT0032S01
When the seatback receives a sharp backward force during a rear-
end collision, the input plate moves with the link rotating center as
a pivot. The headrest will then move towards the front upper direc-
tion with the center of the sliding roller as a pivot.
As the backward force on the seat back is eliminated, spring ten-
sion returns the headrest to its original position.
FRONT SEAT
Removal and Installation (Cont’d)
BT-48
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст