Infiniti I30 (A33). Manual — part 444
APPLICATION ITEMS
NHEL0288S02
Mode
Description
Reference
page
SELF DIAG RESULTS
Displays the result of self-diagnosis.
DATA MONITOR
Two modes, “GPS MONITOR” and “SWITCH MONITOR” can be selected in this
mode.
I
Displays current data related to GPS in “GPS MONITOR” mode.
I
Displays IVCS switch and outside door handle switch condition in “SWITCH
MONITOR” mode.
FUNCTION CHECK
In this mode, “Remote door unlock function” can be checked using CONSULT-II.
Door can be unlocked according to the commands to the smart entrance control
unit by the IVCS unit. This check verifies communication circuit between smart
entrance control unit and IVCS unit.
REGISTERED DATA
Displays the following data registered in the IVCS unit. In this mode the data can-
not be re-written.
I
Unit ID
I
Cellular phone number
I
VIN (Vehicle Identification Number)
CONFIGURATION
(See Note.)
In this mode, the system can be set up in the demonstration mode to confirm sys-
tem operation.
Various data related to both the Communicator Response Center contract and cel-
lular provider can be written/updated in this mode.
I
Phone number
I
NAM (Number Assignment Module)
I
Stolen vehicle tracking setting (Default should always be on.)
I
Alarm notification setting (Default should always be on.)
ECU PART NUMBER
Displays the part number of the IVCS unit.
—
NOTE:
Data must not be rewritten without prior approval from the
customer.
SEL440W
“SELF-DIAG RESULTS” MODE
NHEL0288S03
How to Perform Self-diagnosis
NHEL0288S0301
1.
Touch “SELF-DIAG RESULTS”.
2.
Touch “START”.
SEL441W
3.
If no malfunction is detected, CONSULT-II will show “NO DTC
IS DETECTED.”
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
INFINITI COMMUNICATOR (IVCS)
CONSULT-II (Cont’d)
EL-445
SEL442W
I
If trouble codes are displayed with “TIME = 0”, repair/replace
the system according to “SYMPTOM CHART 1 (SELF-DIAG-
NOSIS ITEM)”, EL-450.
I
In this case, both “MAYDAY” and “INFORMATION” indicator
lamps illuminate for more than 30 seconds while the ignition
switch is in the ON position.
NOTE:
The time data in CONSULT-II “SELF-DIAG RESULTS” mode
displays the number of ignition switch cycles without the
same malfunctioning occurring.
SEL443W
I
If trouble codes are displayed with “TIME = 1 or greater”, it
means that the trouble code is historical data. So no further
diagnosis is required.
NOTE:
If trouble codes are displayed with “TIME = 1 or greater” even
though the INFINITI Communicator has never been serviced.
Intermittent incidents may occur. Check the system, refer to
“Trouble Diagnoses for Intermittent Incident”, EL-459.
I
If the system does not detect any trouble, the IVCS indicators
will turn off after bulb check (self-diagnosis) is completed while
the ignition switch is in the ON position.
NOTE:
I
The trouble codes cannot be erased by CONSULT-II.
I
After 50 ignition cycles, the trouble codes are no longer
displayed in the CONSULT-II “SELF-DIAG RESULTS”
mode.
I
The IVCS unit does not count the ignition switch cycles
unless the ignition switch is OFF for more than 3 minutes
between each ignition switch cycle.
INFINITI COMMUNICATOR (IVCS)
CONSULT-II (Cont’d)
EL-446
“DATA MONITOR” MODE
NHEL0288S04
How to Perform Data Monitor
NHEL0288S0401
SEL444W
Data Monitor Item Chart
NHEL0288S0402
Mode
Monitor item
Description
GPS MONITOR
AVAILABLE GPS
The number of GPS satellites captured by GPS antenna
DATE
Date of Greenwich mean time
GMT TIME
Greenwich mean time (Different from local time)
LAT.
Latitude
LONG.
Longitude
DOP
Index of precision (an index of location status of GPS satellites. The
smaller the value is, the higher the positioning precision is.)
SWITCH MONITOR
MAYDAY
“MAYDAY” emergency switch condition
INFORMATION
“INFORMATION” switch condition
DR HANDLE
Driver side outside door handle switch condition
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
INFINITI COMMUNICATOR (IVCS)
CONSULT-II (Cont’d)
EL-447
SEL445W
“REGISTERED DATA” MODE
NHEL0288S05
Item
Description
UNIT ID
ID number of the IVCS unit. ID number is unique to
each unit and differs for each unit.
CELLULAR PHONE #
—
VIN #
Vehicle Identification Number. When the IVCS unit is
replaced, VIN # is written in the memory of the
replaced unit by transmitting data from the Communi-
cator Response Center.
NOTE:
No data can be changed in this CONSULT-II mode.
INFINITI COMMUNICATOR (IVCS)
CONSULT-II (Cont’d)
EL-448
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст