Infiniti I30 (A33). Manual — part 170
Removal and Installation
NHBT0025
REMOVAL
NHBT0025S01
SBT880
SBT822
INSTALLATION
NHBT0025S02
1.
Install mirror base as follows:
a.
Determine mirror base position on windshield by measuring
from top of windshield to top of mirror base as shown in the
figure.
b.
Mark location on outside of windshield with wax pencil or
equivalent.
c.
Clean attaching point on inside of windshield with an alcohol-
saturated panel towel.
d.
Sand bonding surface of mirror base with sandpaper (No. 320
or No. 360).
e.
Clean bonding surface of mirror base with an alcohol-saturated
paper towel.
f.
Apply Loctite Adhesive 11067-2 or equivalent to bonding sur-
face of mirror base.
g.
Install mirror base at premarked position and press mirror base
against glass for 30 to 60 seconds.
h.
After five minutes, wipe off excess adhesive with an alcohol-
moistened paper towel.
2.
Install rearview mirror.
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
REAR VIEW MIRROR
Removal and Installation
BT-61
Alignment
NHBT0026
I
All dimensions indicated in figures are actual ones.
I
When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge
itself to make sure there is no free play.
I
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
I
Measurements should be taken at the center of the mounting holes.
I
An asterisk (*) following the value at the measuring point indicates that the measuring point on the other
side is symmetrically the same value.
I
The coordinates of the measurement points are the distances measured from the standard line of “X”, “Y”
and “Z”.
SBF874GB
BODY (ALIGNMENT)
Alignment
BT-62
ENGINE COMPARTMENT
NHBT0026S01
Measurement
NHBT0026S0101
SBT881
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
BODY (ALIGNMENT)
Alignment (Cont’d)
BT-63
Measurement Points
NHBT0026S0102
SBT882
BODY (ALIGNMENT)
Alignment (Cont’d)
BT-64
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст