Infiniti QX56 (JA60). Manual — part 1012
WCS-46
< ECU DIAGNOSIS >
COMBINATION METER
ABNIA1299GB
WCS
COMBINATION METER
WCS-47
< ECU DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
Fail Safe
INFOID:0000000005382410
The combination meter performs a fail-safe operation for the functions listed below when communication is
lost.
ABNIA1466GB
WCS-48
< ECU DIAGNOSIS >
COMBINATION METER
DTC Index
INFOID:0000000005382411
NOTE:
Function
Specifications
Speedometer
Zero indication.
Tachometer
Fuel gauge
Engine coolant temperature gauge
Engine oil pressure gauge
Voltage gauge
Illumination control
Meter illumination
Change to nighttime mode when communication is lost.
Segment LCD
Odometer
Freeze current indication.
A/T position
Display turns off.
Buzzer
Buzzer turns off.
Warning lamp/indicator lamp
ABS warning lamp
Lamp turns on when communication is lost.
Brake warning lamp
VDC OFF indicator lamp
SLIP indicator lamp
A/T CHECK warning lamp
Lamp turns off when communication is lost.
Oil pressure/coolant temperature
warning lamp
Light indicator
Malfunction indicator lamp
Master warning lamp
Air bag warning lamp
High beam indicator
Turn signal indicator lamp
CRUISE indicator lamp
Driver and passenger seat belt warn-
ing lamp
Lamp turns off when disconnected.
Charge warning lamp
Security indicator lamp
4WD indicator lamp
ATP indicator lamp
CK SUSP warning lamp
Low tire pressure warning lamp
Lamp will flash every second for 1 minute and then stay on con-
tinuously thereafter.
CONSULT-III display
Malfunction
Reference
page
CAN COMM CIRC
[U1000]
Malfunction is detected in CAN communication.
CAUTION:
Even when there is no malfunction on CAN communication system, malfunction may be
misinterpreted when battery has low voltage (when maintaining 7 - 8 V for about 2 sec-
onds) or 10A fuse [No. 3, located in the fuse block (J/B)] is disconnected.
VEHICLE SPEED
CIRC
[B2205]
Malfunction is detected when an erroneous speed signal is input.
CAUTION:
Even when there is no malfunction on speed signal system, malfunction may be misin-
terpreted when battery has low voltage (when maintaining 7 - 8 V for about 2 seconds).
WCS
COMBINATION METER
WCS-49
< ECU DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
“TIME” indicates the following.
• 0: Indicates that a malfunction is detected at present.
• 1-63: Indicates that a malfunction was detected in the past. (Displays number of ignition switch OFF
→ ON
cycles after malfunction is detected. Self-diagnosis result is erased when “63” is exceeded.)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст