Infiniti QX56 (JA60). Manual — part 836
FRONT SEAT
SE-69
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
Disassembly and Assembly
INFOID:0000000005256345
SEATBACK TRIM AND PAD
Disassembly
CAUTION:
• Only complete seatback assemblies can be replaced on vehicles equipped with side air bags.
• When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
1. Remove the seatback assembly. Refer to
SE-51, "Removal and Installation"
.
2. Remove the headrest.
3. From inside of the seatback, squeeze the headrest holder tabs
at the base of the stay pipe and pull the up to remove.
NOTE:
Before installing the headrest holder, check its orientation (front/
rear and right/left).
4. Remove the snap ring and the lumbar support lever knob (if
equipped).
5. Remove the seatback trim and pad assembly.
6. Remove the hog rings to separate the seatback trim from the pad.
Assembly
Assembly is in the reverse order of disassembly.
SEAT CUSHION TRIM AND PAD
Disassembly
CAUTION:
• Front passenger seat is equipped with an Occupant Classification System sensor and control mod-
ule. Do not disassemble front passenger seat cushion assembly or remove the trim as this will affect
the Occupant Classification System calibration.
• Always replace passenger seat cushion as an assembly.
• When removed, the passenger seat cushion must always be placed pan side UP to prevent damage.
• During installation, the wire harness clips must be reinstalled in the holes they were originally in. Do
not add additional clips.
• The Occupant Classification System control module can only be replaced as part of the seat cushion
assembly.
19. Outer pedestal finisher
20. Seat cushion outer finisher
21. Seat cushion assembly
22. Power seat switch escutcheon
23. Slide switch knob
24. Recliner switch knob
25. Seatback assembly
26. Headrest holder
27. Seat slide/ recline switch
28. Power lumbar switch
LRS023
PIIA1156E
SE-70
< DISASSEMBLY AND ASSEMBLY >
FRONT SEAT
1. Remove the recline release lever.
2. Remove four bolts and the seat cushion assembly.
• On the fold flat passenger seat it is necessary to unclip the
rear flap j-clip from the seat pan.
3. On the drivers seat only, remove the seat cushion trim and pad.
4. On the drivers seat only, remove the hog rings to separate the trim cover from the pad.
Assembly
Assembly is in the reverse order of disassembly.
PASSENGER SEATBACK BOARD - SOFT SEATBACK
Removal
1. The seatback board is attached to the seat frame with the follow-
ing:
• 2 top tabs (A)
• 4 side tabs (B)
• 2 bottom clips (C) (must be replaced)
2. Move seat to forward position.
3. Hold the seatback board as shown and pull the top of the seat-
back board away from the seat back frame.
4. Pull the middle part of the seatback board to disengage the side
tabs (B) from the seatback frame.
5. Pull the lower part of the seatback board to disengage the bot-
tom clips from the seatback frame.
SIIA0503E
ALIIA0394ZZ
ALIIA0368ZZ
ALIIA0367ZZ
FRONT SEAT
SE-71
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
Installation
Installation is in the reverse order of removal.
PASSENGER SEATBACK BOARD - HARD SEATBACK
Removal
1. The seatback board is attached to the seat frame with the follow-
ing:
• 2 top tabs (A)
• 2 side tabs (B)
• 2 bottom clips (C) (must be replaced)
2. Move seat to forward position.
3. Hold the seatback board as shown and pull the bottom of the
seatback board away from the seat back frame.
4. Pull the middle part of the seatback board to disengage the side
tabs (B) from the seatback frame.
5. Lift the upper part of the seatback board to disengage the top
tabs from the seatback frame.
Installation
Installation is in the reverse order of removal.
ALIIA0395ZZ
ALIIA0370ZZ
ALIIA0371ZZ
SE-72
< DISASSEMBLY AND ASSEMBLY >
SECOND SEAT
SECOND SEAT
Disassembly and Assembly
INFOID:0000000005147419
Second Row RH
WIIA1013E
1.
Headrest
2.
Seatback pad
3.
Seatback frame
4.
Rear seat bezel
5.
RH Headrest guide (free)
6.
LH Headrest guide (locking)
7.
Seat back panel
8.
Seat actuator assembly
9.
Reclining device inner cover
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст