Infiniti G35 (V35). Manual — part 279
COMPASS
DI-63
C
D
E
F
G
H
I
J
L
M
A
B
DI
Calibration Procedure for Compass
NKS000L3
The difference between magnetic North and geographical North can sometimes be great enough to cause
false compass readings.
In order for the compass to operate accurately in a particular zone, it must be calibrated using the following
procedure.
SKIA2076E
DI-64
COMPASS
CORRECTION FUNCTIONS OF COMPASS
If the direction is not shown correctly, perform initial correction.
INITIAL CORRECTION PROCEDURE FOR COMPASS
1.
Pushing the “COMP” switch for about 10 seconds will enter the
initial correction mode. The direction bar starts blinking.
2.
Turn off all electrical equipment (turn signals, hazard signal, A/
C, lights, etc.). In a broad, flat, and safe location, drive the vehi-
cle slowly [approximately 5 km/h (3 MPH) or less], and turn the
vehicle 360
°
or more several times. When the direction appears
on the display, correction is complete.
NOTE:
The correct direction may not be shown in locations where the
earth's magnetic field is disrupted, such as those listed below.
●
Elevated bridges
●
Railroad crossings
●
Streets lined with large buildings
●
Iron bridges
●
Tunnels
●
Locations above subways
●
Underground parking areas
●
Near large vehicles
●
Electric power substations
If display correction is performed in any of the above locations, accurate correction may not be possible.
●
When heater or A/C fan speed is at maximum, the direction indicator display may move. This is not a mal-
function. It will return to normal when the heater or A/C fan speed is reduced.
Removal and Installation of Compass
NKS000L4
REMOVAL
1.
Remove instrument panel and pad. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
2.
Remove screw (1), and remove compass.
INSTALLATION
Installation is the reverse order of removal.
PKIB3830E
PKIA2379E
CLOCK
DI-65
C
D
E
F
G
H
I
J
L
M
A
B
DI
CLOCK
PFP:25820
Removal and Installation of Clock
NKS000LQ
REMOVAL
1.
Remove the display and A/C auto amp. and clock assembly.
Refer to
ATC-114, "Removal and Installation of Display and A/C
.
2.
Disconnect clock connector.
3.
Disengage tabs (4), and remove clock.
INSTALLATION
Installation is the reverse order of removal.
SKIB4711E
SKIB4712E
DI-66
CLOCK
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст