Infiniti G35 (V35). Manual — part 640
MT-28
TRANSMISSION ASSEMBLY
14. Remove withdrawal lever ball pin and washer from front cover.
15. Remove front cover mounting bolts. Then remove front cover
and front cover gasket from transmission case.
16. Remove front cover oil seal from front cover using a flat-bladed
screwdriver.
CAUTION:
Be careful not to damage front cover mating surface.
17. Remove baffle plate mounting nut from transmission case.
18. Remove snap ring from main drive gear bearing using snap ring
pliers.
19. Carefully tap on transmission case to separate it from adapter
plate using a soft hummer.
PCIB0230E
PCIB0714E
SCIA1443E
PCIB0715E
SCIA1687E
TRANSMISSION ASSEMBLY
MT-29
D
E
F
G
H
I
J
K
L
M
A
B
MT
20. Remove counter front bearing from transmission case.
21. Remove oil gutter from transmission case.
Shift Control Components
1.
Install adapter setting plate to adapter plate, and then secure
adapter setting plate in a vise.
2.
Remove baffle plate mounting bolts and baffle plate from
adapter plate.
NOTE:
Mounting bolts are installed both from the front side and the
reverse side of adapter plate.
3.
Remove magnet from adapter plate.
4.
Drive out retaining pin using a pin punch [6 mm (0.24 in) dia.],
and remove striking lever and striking rod.
PCIB0436E
Tool number
: ST22490000 (
—
)
PCIB0254E
PCIB0716E
PCIB0414E
MT-30
TRANSMISSION ASSEMBLY
5.
Remove check ball plugs, check ball springs and check balls
from adapter plate.
6.
Remove 3rd-4th control lever mounting bolts and 3rd-4th control
lever from adapter plate.
7.
Remove shifter cap from 3rd-4th control lever.
8.
Remove check ball plug, check ball spring and check ball from
adapter plate.
9.
Drive out retaining pin using a pin punch [6mm (0.24 in) dia.],
and remove 3rd-4th fork rod bracket and 3rd-4th fork rod.
PCIB0143E
PCIB0235E
PCIB0144E
PCIB0717E
TRANSMISSION ASSEMBLY
MT-31
D
E
F
G
H
I
J
K
L
M
A
B
MT
10. Drive out retaining pin using a pin punch [6 mm (0.24 in) dia.],
and remove 3rd-4th fork rod (reversal side) and 3rd-4th shift
fork.
11. Remove check balls and interlock pin from adapter plate.
12. Drive out retaining pin using a pin punch [6 mm (0.24 in) dia.],
and remove 1st-2nd fork rod and 1st-2nd shift fork.
13. Remove interlock plunger and interlock pin from adapter plate.
14. Drive out retaining pin using a pin punch [6 mm (0.24 in) dia.],
and remove reverse fork rod and reverse shift fork.
PCIB0718E
PCIB0146E
PCIB0602E
PCIB0147E
SCIA1447E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст