Infiniti G35 (V35). Manual — part 59
ON-VEHICLE SERVICE
AT-227
D
E
F
G
H
I
J
K
L
M
A
B
AT
11. Disconnect A/T fluid temperature sensor 2 connector (A).
CAUTION:
Be careful not to damage connector.
12. Straighten terminal clips to free terminal cord assembly and A/T
fluid temperature sensor 2 harness.
●
: Terminal clip (4)
13. Disconnect revolution sensor connector.
CAUTION:
Be careful not to damage connector.
14. Straighten terminal clip to free revolution sensor harness.
15. Remove bolts A, B and C from control valve with TCM.
●
: Vehicle front
SCIA8124E
SCIA7524E
SCIA7525E
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA8074E
AT-228
ON-VEHICLE SERVICE
16. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with the manual valve notch and
manual plate height. Remove it vertically.
17. Remove A/T fluid temperature sensor 2 with bracket from con-
trol valve with TCM.
18. Remove bracket from A/T fluid temperature sensor 2.
19. Remove O-ring from A/T assembly harness connector.
20. Disconnect TCM connectors.
CAUTION:
Be careful not to damage connectors.
SCIA5142E
SCIA5301E
SCIA5264E
SCIA5155E
SCIA5447E
ON-VEHICLE SERVICE
AT-229
D
E
F
G
H
I
J
K
L
M
A
B
AT
21. Remove A/T assembly harness connector from control valve
with TCM using a flat-bladed screwdriver.
22. Disconnect TCM connector and park/neutral position switch
connector.
CAUTION:
Be careful not to damage connectors.
Installation
CAUTION:
After completing installation, check A/T fluid leakage and A/T fluid level. Refer to
,
1.
Connect TCM connector and park/neutral position switch con-
nector.
2.
Install A/T assembly harness connector from control valve with
TCM.
SCIA5448E
SCIA5449E
SCIA5449E
SCIA5450E
AT-230
ON-VEHICLE SERVICE
3.
Connect TCM connectors.
4.
Install O-ring in A/T assembly harness connector.
CAUTION:
●
Do not reuse O-ring.
●
Apply ATF to O-ring.
5.
Install A/T fluid temperature sensor 2 to bracket.
6.
Install A/T fluid temperature sensor 2 (with bracket) in control
valve with TCM, and then tighten A/T fluid temperature sensor 2
bolt to the specified torque. Refer to
CAUTION:
Adjust bolt hole of bracket to bolt hole of control valve with
TCM.
7.
Install control valve with TCM in transmission case.
CAUTION:
●
Make sure that turbine revolution sensor securely installs
turbine revolution sensor hole.
●
Hang down revolution sensor harness toward outside so
as not to disturb installation of control valve with TCM.
●
Adjust A/T assembly harness connector of control valve
with TCM to terminal hole of transmission case.
SCIA5447E
SCIA5155E
SCIA5264E
SCIA5301E
SCIA5034E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст