Infiniti G35 (V35). Manual — part 693
RF-28
SUNROOF
3.
Remove TORX bolts (T25) and then detach glass lid.
Installation
1.
Tighten bolts diagonally on the glass lid.
2.
After installation, carry out fitting adjustment.
SUNSHADE
Removal
NOTE:
Removing is possible even by the on vehicle.
1.
Remove the headlining. Refer to
EI-36, "Removal and Installation"
2.
Remove sunshade stopper.
3.
Pull sunshade to the rear end of the sunroof frame, then remove
it from the sunroof frame.
CAUTION:
Thing working to damage neither sunshade and sunshade
knob while lifting up a little.
Installation
Install in the reverse order of removal.
WIND DEFLECTOR
Removal
NOTE:
Removing is possible even by the on vehicle.
1.
Sunroof lid is fully open.
2.
Remove spring hinge screws and then remove hinge from the
frame.
3.
Remove the stopper from the sunroof unit assembly.
4.
Turn the wind deflector and then remove it from ditch of the sun-
roof unit assembly.
Installation
Install in the reverse order of removal.
PIIA3508E
PIIA3506E
PIIA3510E
SUNROOF
RF-29
C
D
E
F
G
H
J
K
L
M
A
B
RF
SUNROOF MOTOR ASSEMBLY
Removal
1.
EI-36, "Removal and Installation"
2.
Remove sunroof motor mounting screw.
3.
Disconnect harness connector from sunroof motor, then remove
sunroof motor assembly.
CAUTION:
●
When removing the sunroof motor assembly, be sure that
the sunroof is in the fully open position.
●
Do not run the removed sunroof motor assembly as a
single unit.
Installation
Move the sunroof motor assembly laterally little by little so that the gear is completely engaged into the wire on
the sunroof unit assembly and the mounting surface becomes parallel. Tighten the sunroof motor assembly
with screws.
CAUTION:
●
Before installing the sunroof motor assembly, be sure to place the link and wire assembly in the
symmetrical and fully closed position.
●
Initialization of it after installing the sunroof motor. Refer to
RF-11, "INITIALIZATION PROCEDURE"
.
PIIA3502E
RF-30
SUNROOF
RFD-1
REAR FINAL DRIVE
D DRIVELINE/AXLE
CONTENTS
C
E
F
G
H
I
J
K
L
M
SECTION
A
B
RFD
REAR FINAL DRIVE
PRECAUTIONS . . . . . . . . . . . . . . .. 2
Service Notice or Precautions . . . . . . . . .. 2
PREPARATION . . . . . . . . . . . . . . ... 3
Special Service Tools . . . . . . . . . . . ... 3
Commercial Service Tools . . . . . . . . . . 6
NOISE, VIBRATION AND HARSHNESS (NVH)
TROUBLESHOOTING . . . . . . . . . . . . 7
NVH Troubleshooting Chart . . . . . . . . . . 7
DESCRIPTION . . . . . . . . . . . . . . . 8
Cross-Sectional View . . . . . . . . . . . ... 8
DIFFERENTIAL GEAR OIL . . . . . . . . . . 9
Changing Differential Gear Oil . . . . . . . . . 9
DRAINING . . . . . . . . . . . . . . . . 9
FILLING . . . . . . . . . . . . . . . . . 9
Checking Differential Gear Oil . . . . . . . . .. 9
OIL LEAKAGE AND OIL LEVEL . . . . . . ... 9
FRONT OIL SEAL . . . . . . . . . . . . . 10
Removal and Installation . . . . . . . . . . 10
SIDE OIL SEAL . . . . . . . . . . . . . . 15
Removal and Installation . . . . . . . . . . 15
REMOVAL . . . . . . . . . . . . . . ... 15
INSTALLATION . . . . . . . . . . . . ... 15
REAR FINAL DRIVE ASSEMBLY . . . . . . . 17
Removal and Installation . . . . . . . . . . 17
Disassembly and Assembly (R200 2-Pinion) . . . 19
Disassembly and Assembly (R200V LSD) . . . . 39
SERVICE DATA AND SPECIFICATIONS (SDS) . .. 59
General Specifications . . . . . . . . . . . 59
Inspection and Adjustment . . . . . . . . . . 59
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст