Infiniti G35 (V35). Manual — part 250
VDC/TCS/ABS ACTUATOR
BRC-61
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
VDC/TCS/ABS ACTUATOR
PFP:47660
Removal and Installation
NFS0007S
Pay attention to the following when removing VDC actuator.
CAUTION:
●
Before servicing, disconnect the battery cable from the negative terminal.
●
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being dam-
aged. To install, use a flare nut crowfoot and torque wrench (commercial service tool).
●
Do not remove and install VDC actuator by holding harness.
●
After work is completed, bleed air from brake piping. Refer to
BR-10, "Bleeding Brake System"
.
●
Be sure to securely connect the battery cable to the negative terminal.
SFIA2748E
BRC-62
[VDC/TCS/ABS]
G-SENSOR
G-SENSOR
PFP:47930
Removal and Installation
NFS0007T
REMOVAL
A/T Models
1.
Remove center console. Refer to
2.
Disconnect harness connector.
3.
Remove installation bolts. Remove yaw rate/side G sensor.
CAUTION:
●
Do not drop or strike yaw rate/side G sensor, because it has
little endurance to impact.
●
Do not use power tool etc., because yaw rate/side G sensor
is sensitive for the impact.
M/T Models
1.
Remove center console. Refer to
2.
Disconnect harness connector.
3.
Remove installation bolts. Remove yaw rate/side G sensor.
CAUTION:
●
Do not drop or strike yaw rate/side G sensor, because it has
little endurance to impact.
●
Do not use power tool etc., because yaw rate/side G sensor
is sensitive for the impact.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
●
Do not drop or strike yaw rate/side G sensor, because it has little endurance to impact.
●
Do not use power tool etc., because yaw rate/side G sensor is weak for the impact.
SFIA0703E
SFIA0934E
STEERING ANGLE SENSOR
BRC-63
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
STEERING ANGLE SENSOR
PFP:25554
Removal and Installation
NFS0007U
REMOVAL
1.
Remove spiral cable assembly. Refer to
.
2.
Remove steering angle sensor from spiral cable assembly.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
After work, make sure to adjust neutral position of steering angle sensor. Refer to
Steering Angle Sensor Neutral Position"
SFIA1404E
BRC-64
[VDC/TCS/ABS]
STEERING ANGLE SENSOR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст