Infiniti G35 (V35). Manual — part 69
DISASSEMBLY
AT-267
D
E
F
G
H
I
J
K
L
M
A
B
AT
19. Remove needle bearing (front side) from mid carrier assembly.
20. Remove needle bearing (rear side) from mid carrier assembly.
21. Remove bearing race from rear carrier assembly.
22. Remove needle bearing from rear carrier assembly.
23. Remove mid sun gear assembly, rear sun gear assembly and
high and low reverse clutch hub as a unit.
CAUTION:
Be careful to remove then with bearing race and needle
bearing.
SCIA2805E
SCIA2804E
SCIA5175E
SCIA2803E
SCIA5018E
AT-268
DISASSEMBLY
24. Remove high and low reverse clutch assembly from direct clutch
assembly.
CAUTION:
Make sure that needle bearing is installed to the high and
low reverse clutch assembly edge surface.
25. Remove direct clutch assembly from reverse brake.
26. Remove needle bearing from drum support.
27. Remove snap ring from A/T assembly harness connector.
28. Push A/T assembly harness connector.
CAUTION:
Be careful not to damage connector.
SCIA2306E
SCIA5019E
SCIA5198E
SCIA5021E
SCIA5022E
DISASSEMBLY
AT-269
D
E
F
G
H
I
J
K
L
M
A
B
AT
29. Remove clips (1).
30. Remove oil pan (2) and oil pan gasket.
●
: Front
●
: Bolt (22)
●
Drain plug (3)
31. Check foreign materials in oil pan to help determine causes of
malfunction. If the ATF is very dark, smells burned, or contains
foreign particles, the frictional material (clutches, band) may
need replacement. A tacky film that will not wipe clean indicates
varnish build up. Varnish can cause valves, servo, and clutches
to stick and can inhibit pump pressure.
●
If frictional material is detected, perform A/T fluid cooler
cleaning. Refer to
AT-14, "A/T Fluid Cooler Cleaning"
.
32. Remove magnets from oil pan.
33. Disconnect A/T fluid temperature sensor 2 connector (A).
CAUTION:
Be careful not to damage connector.
34. Straighten terminal clips to free terminal cord assembly and A/T
fluid temperature sensor 2 harness.
●
: Terminal clip (4)
35. Disconnect revolution sensor connector.
CAUTION:
Be careful not to damage connector.
SCIA8117E
SCIA5199E
SCIA5200E
SCIA8124E
SCIA7524E
AT-270
DISASSEMBLY
36. Straighten terminal clip to free revolution sensor harness.
37. Remove bolts A, B and C from control valve with TCM.
●
: Front
38. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with the manual valve notch and
manual plate height. Remove it vertically.
39. Remove A/T fluid temperature sensor 2 with bracket from con-
trol valve with TCM.
40. Remove bracket from A/T fluid temperature sensor 2.
SCIA7526E
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA8077E
SCIA5260E
SCIA5301E
SCIA5264E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст