Infiniti G35 (V35). Manual — part 27
DTC U1000 CAN COMMUNICATION LINE
AT-99
D
E
F
G
H
I
J
K
L
M
A
B
AT
Wiring Diagram — AT — CAN
NCS000CC
TCWM0407E
AT-100
DTC U1000 CAN COMMUNICATION LINE
TCM terminals and data are reference value. Measured between each terminal and ground.
Diagnostic Procedure
NCS000CD
1.
CHECK CAN COMMUNICATION CIRCUIT
With CONSULT-II
1.
Turn ignition switch ON and start engine.
2.
Select “SELF-DIAG RESULTS” mode for “A/T” with CONSULT-
II.
Is any malfunction of the “U1000 CAN COMM CIRCUIT” indicated?
YES
>> Print out CONSULT-II screen, go to LAN section. Refer
to
LAN-47, "CAN System Specification Chart"
.
NO
>> INSPECTION END
Terminal
Wire
color
Item
Condition
Data (Approx.)
3
L
CAN-H
–
–
8
P
CAN-L
–
–
PCIA0061E
DTC P0615 START SIGNAL CIRCUIT
AT-101
D
E
F
G
H
I
J
K
L
M
A
B
AT
DTC P0615 START SIGNAL CIRCUIT
PFP:25230
Description
NCS000CE
Prohibits cranking other at “P” or “N” position.
CONSULT-II Reference Value
NCS000CF
On Board Diagnosis Logic
NCS000CG
●
This is not an OBD-II self-diagnostic item.
●
Diagnostic trouble code “P0615 STARTER RELAY/CIRC” with CONSULT-II or 14th judgment flicker with-
out CONSULT-II is detected when starter relay is switched ON other than at “P” or “N” position. (Or when
switched OFF at “P” or “N” position).
Possible Cause
NCS000CH
●
Harness or connectors.
(Starter relay and TCM circuit is open or shorted.)
●
Starter relay circuit.
DTC Confirmation Procedure
NCS000CI
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC Confirmation Procedure” has been previously conducted, always turn ignition switch OFF and
wait at least 10 seconds before conducting the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch ON.
2.
Select “SELECTION FROM MENU” in “DATA MONITOR” mode
for “A/T” with CONSULT-II and check monitor “STARTER
RELAY” ON/OFF.
3.
Start the engine.
4.
Vehicle start for at least 2 consecutive seconds.
5.
AT-103, "Diagnostic Procedure"
Item name
Condition
Display value
STARTER RELAY
Selector lever in “N” and “P” positions.
ON
Selector lever in other positions.
OFF
BCIA0031E
AT-102
DTC P0615 START SIGNAL CIRCUIT
Wiring Diagram — AT — STSIG
NCS000CJ
TCWM0408E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст