Infiniti G20 (P11). Manual — part 136
SBT858
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
EXTERIOR
Removal and Installation (Cont’d)
BT-39
Removal and Installation
NCBT0014
I
When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage.
★
For Wiring Diagram, refer to EL-144, “Wiring Diagram — SEAT —”.
CAUTION:
I
Before removing the rear seat, turn the ignition switch off, disconnect both battery cables and wait
at least 3 minutes.
I
When checking the power seat circuit for continuity using a circuit tester, do not confuse its con-
nector with the side air bag module connector. Such an error may cause the air bag to deploy.
I
Do not drop, tilt, or bump the side air bag module installed in the seat. Always handle it with care.
I
Disconnect the side air bag harnes connector, power seat switch harness connector and heated
seat harness connector from under the seat before removing the seat.
I
Disconnect the side air bag harness connector before removing the seat back. (Refer to RS-23,
“Side Air Bag Module”.)
FRONT SEAT
Removal and Installation
BT-40
POWER SEAT
NCBT0014S01
SBT660
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
FRONT SEAT
Removal and Installation (Cont’d)
BT-41
HEATED SEAT
=NCBT0014S03
I
When handling seat, be extremely careful not to scratch heating unit.
I
To replace heating unit, seat trim and pad should be separated.
I
Do not use any organic solvent, such as thinner, benzene, alcohol, gasoline, etc. to clean trims.
★
For Wiring Diagram, refer to EL-145, “Wiring Diagram — HEATED SEAT —”.
FRONT SEAT
Removal and Installation (Cont’d)
BT-42
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст