Infiniti G20 (P11). Manual — part 129
Description
NCBT0003
I
Clips and fasteners in BT section correspond to the following numbers and symbols.
I
Replace any clips and/or fasteners which are damaged during removal or installation.
Symbol
No.
Shapes
Removal & Installation
C101
SBF302H
SBF367BA
C103
SBT095
SBF423H
C203
SBF258G
SBF708E
C205
MBT080A
SBF638CA
CE103
SBF104B
SBF147B
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
CLIP AND FASTENER
Description
BT-11
Symbol
No.
Shapes
Removal & Installation
CE117
SBF174D
SBF175DA
CF118
SBF151D
SBF259G
CR103
SBF768B
SBF770B
CS101
SBF078B
SBF992G
CLIP AND FASTENER
Description (Cont’d)
BT-12
Removal and Installation
NCBT0004
I
When removing or installing hood, place a cloth or other padding on the front fender panels and cowl top.
This prevents vehicle body from being scratched.
I
Bumper fascia is made of plastic. Do not use excessive force and be sure to keep oil away from it.
I
Hood adjustment: Adjust at hinge portion.
I
Hood lock adjustment: After adjusting, check hood lock control operation. Apply a coat of grease to hood
locks engaging mechanism.
I
Hood opener: Do not attempt to bend cable forcibly. Doing so increases effort required to unlock hood.
FRONT BUMPER ASSEMBLY
NCBT0004S01
1. Remove fog lamp rim.
2. Remove bolt securing fog lamp assembly. Then disconnect fog lamp connector.
3. Remove clips securing bumper fascia to engine undercover.
4. Remove bolts securing bumper fascia to radiator core lower support.
5. Remove screws and clips securing left and right sides of front fender protector.
6. Remove bolts securing left and right front fenders to bumper fascia.
7. Remove clips securing bumper reinforcement assembly to bumper fascia.
8. Extract bumper fascia assembly.
9. Remove energy absorber.
10. Remove bolts and nuts securing headlamp assembly.
11. Remove bolt and nuts securing bumper reinforcement assembly.
12. Remove the pin from the bolts which fix the bumper reinforcement assembly.
13. Remove bolts securing bumper reinforcement assembly.
14. Extract bumper reinforcement assembly.
SBT679
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
BODY FRONT END
Removal and Installation
BT-13
SBT850
BODY FRONT END
Removal and Installation (Cont’d)
BT-14
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст