Volkswagen Golf / Golf GTI / Jetta. Manual — part 533
19. Shield plate
20. Retainer for parking brake cable
21. Parking brake cable
22. Hex bolt, 75 Nm
¡
Always replace
¡
For removal of rear axle, do
not loosen if possible
23. Self-locking hex nut, 80 Nm
¡
Always replace
¡
When tightening nut, the axle
beam must be in the horizontal
position (unladen vehicle
state)
24. Hex bolt, 80 Nm
¡
Always replace
25. Rear axle bearing bracket
¡
Check and if necessary adjust
rear axle total track after
installation
¡
If possible do not loosen when
removing the rear axle
26. Hydraulic bonded rubber bushing
If weld nut threads are damaged,
threads can be repaired using
Heli-Coil thread inserts.
Servicing thread in side rail
40-3, Threads in longitudinal
member, servicing
Distinguish between bonded
rubber bushing
Item - 27 -
.
The hydraulic bonded rubber
bushing has a bulge - arrow - ,
to the exterior of vehicle.
Bushing must be replaced if
Rear axle, servicing
¡
Removing and installing
42-
2, Hydraulic bonded rubber
bushing, removing and
installing
27. Bonded rubber bushing
¡
Removing and installing
42-
2, Bonded rubber bushing,
removing and installing
28. Parking brake cable clip
29. Bolt, 20 Nm plus an additional 1/8
turn 45
¡
Always replace
30. Vibration damper
¡
Always replace
leaking
Bonded rubber bushing, removing and
installing
Rear axle, servicing
Special tools, testers and auxiliary items
required
n
Torque wrench V.A.G1332
n
Engine/transmission jack V.A.G
1383 A with universal transmission
mount V.A.G1359/2
n
Brake pedal depressor V.A.G1869/2
n
Tensioning strap T10038
n
Wheel hub support T10149
n
Hydraulic press VAS 6178
n
Hollow piston cylinder VAS 6179
n
Assembly tool VAS 6180
Rear axle, servicing
Removing
- Measure dimension - a - from the center of the wheel to
lower edge of wheel housing.
- Make a note of the measurement. This is necessary to
tighten bolts for rear axle to bearing bracket.
- Install brake pedal loading device V.A.G1869/2 .
- Lift vehicle on lifting platform.
- Remove wheels.
- Separate brake lines - arrowA - and remove clip.
- Remove left brake hose from bracket - 2 - .
- Remove right brake hose from rear axle.
- Remove parking brake cable from brackets - arrow B - .
- Support rear axle with engine/transmission jack
V.A.G1383A .
- Remove bolt - 1 - for bearing bracket on rear axle on both
sides.
- Lower rear axle using engine/transmission jack
V.A.G1383A .
Rear axle, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст