Volkswagen Golf / Golf GTI / Jetta. Manual — part 49
15-85
System in basic setting 1
1
2
3
4
Indicated on display: (1...4
display
zones)
Only continue with the test when:
Checking intake camshaft timing
adjustment
Coolant temperature is above 85
C -Display zone 2-
- Change to display group 94 as
follows:
- Press C key.
Basic setting
Input display group number XXX
Indicated on display
- Press keys 0, 9 and 4 for "Display
group number 94" and confirm
entry with Q key.
System in basic setting 94
1
2
3
Indicated on display: (1...3
display
zones)
- Depress brake pedal and hold.
- Depress accelerator down to wide
open throttle position.
Engine speed will be increased by
engine control module to approx.
2300 rpm.
Valve gear, servicing
15-86
- Hold brake pedal and accelerator down until
display in display zone 3 jumps from "Test OFF"
to "Test ON".
- Continue to hold brake pedal and accelerator
down until display zone 3 displays specification
"Syst. OK."..
- Release brake and accelerator pedals.
If "Syst.n.OK." appears in display zone 3:
- Press
key.
- Check DTC memory:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
- Read readiness code:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
- Generate readiness code again if DTC memory
has been erased or engine control module
separated from permanent positive supply:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
Valve gear, servicing
15-87
If no DTC is stored in DTC memory:
- Press keys 0 and 6 for function "End output" and
confirm entry with Q key.
- Switch ignition off.
- Check Camshaft Position (CMP) sensors -G40-
and -G163- (connections may be interchanged):
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
28
- Check oil pressure
Page 17-19
, Checking oil
pressure and oil pressure switch.
- Check valve timing
Page 15-37
.
When no faults can be located:
- Replace intake camshaft timing adjuster
Page
15-69
, Removing and installing camshaft
If "Sys. OK." appears in display zone 3:
Valve gear, servicing
15-88
Check exhaust camshaft timing
adjustment
- Change to display group 96 as
follows:
- Press C key.
Basic setting
Input display group number XXX
Indicated on display
- Press keys 0, 9 and 6 for "Display
group number 96" and confirm
entry with Q key.
System in basic setting 96
1
2
3
Indicated on display: (1...3
display
zones)
- Depress brake pedal and hold.
- Depress accelerator down to wide
open throttle position.
Engine speed will be increased by
engine control module to approx.
2300 rpm.
- Hold brake pedal and accelerator
down until display in display zone
3 jumps from "Test OFF" to "Test
ON".
- Continue to hold brake pedal and
accelerator down until display
zone 3 displays specification
"Syst. OK.".
Valve gear, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст