Volkswagen Golf / Golf GTI / Jetta. Manual — part 329
39-16
A - Counter support, e.g. Kukko
22/2
B - Internal puller 46 to 58 mm, e.g.
Kukko 21/7
Note:
After pulling out, check washer for
damage and replace if necessary.
Fig. 1
Pulling tapered roller
bearing outer race out
of clutch housing
Fig. 2
Pressing tapered roller
bearing outer race into
clutch housing
- First insert washer.
Differential, disassembling and assembling
39-17
Note:
Both tapered roller bearing inner
races are pulled off the differential
housing in the same way.
Fig. 3
Pulling off tapered roller
bearing inner race
- Before mounting extractor
position press piece 40-105 on
differential housing.
Note:
The tapered roller bearing inner
races for the transmission housing
and clutch housing are pressed on
with the same press tools.
Fig. 4
Pressing on tapered
roller bearing inner race
Differential, disassembling and assembling
39-18
A - Counter support, e.g. Kukko
22/2
B - Internal puller 46 to 58 mm, e.g.
Kukko 21/7
Fig. 5
Pulling tapered roller
bearing outer race out
of transmission housing
Fig. 6
Pressing tapered roller
bearing outer race into
transmission housing
- Support transmission housing
with tube 3345 directly below
bearing mounting.
Differential, disassembling and assembling
39-19
Note:
Clean differential before and after
drilling. Protect tapered roller bearing
from metal particles.
Fig. 7
Drilling out rivet heads
- Drill out rivet heads with 12 mm
drill from countersunk side and
drive rivet out with drift.
Fig. 8
Pressing off final drive
gear
- Place thrust piece 40-105 on
differential housing.
Differential, disassembling and assembling
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст