Volkswagen Golf / Golf GTI / Jetta. Manual — part 452
46-53
Note:
- Insert brake pads and brake pad
retaining springs (arrows) into
brake carrier.
- Remove protective foil off outer
brake pad backplate.
- Secure brake caliper housing with
new self-locking bolts.
Torque: 35 Nm (26 ft lb.)
The repair kit includes four self-
locking hex bolts which must be
installed in all cases.
Repair Manual, Suspension,
Wheels, Steering, Repair Group 44;
Tightening wheel bolts
Note:
- Press brake lever -2- in direction
of arrow and attach parking brake
cable.
- Install clip -1-.
- Adjusting parking brake
Page
46-71
.
- Install wheels.
After each brake pad change,
firmly depress brake pedal
several times with vehicle
stationary, so that the brake pads
are properly seated in their
normal operating position.
After changing brake pads check
brake fluid level.
Rear wheel brakes (disc brakes - front wheel drive), assembly overview
46-54
Parking brake, adjusting
Note:
A new adjustment is only necessary after
replacing, parking brake cables, brake calipers
and brake discs.
- Remove center console extension,
Repair Manual, Body Interior, Repair Group
68; Compartments, covers and trims; Removing
center console extension
- Firmly depress brake pedal three times.
- Pull parking brake three times and then release
again.
Note:
Due to the automatic rear wheel brake adjustment
there is no requirement to adjust the parking brake
after making new/initial adjustment.
- Parking brake lever in "rest/off" position. Tighten
adjusting nut until lever -arrow- lifts off the brake
caliper stop.
- A gap of min. 1.0 mm (.039 in.) and max. 3.0
mm (.118 in.) from stop (arrow) is permissible on
each side.
- Check that both wheels turn freely. Adjust the
adjustment nut if necessary.
Rear wheel brakes (disc brakes - front wheel drive), assembly overview
46-55
Rear wheel
brakes/disc
brakes (all-
wheel
drive),
servicing
Special tools and
equipment
VAG 1331
Torque
wrench
VAG 1332
Torque
wrench
VAG 1410
Torque
wrench
VAG 1869/2
Brake pedal
depressor
Rear wheel brakes/disc brakes (all-wheel drive), servicing
46-56
Note:
After
replacing
brake pads,
depress
brake pedal
firmly several
times with
vehicle
stationary so
that the brake
pads are
properly
seated in
their normal
operating
position.
To draw off
brake fluid
from the
reservoir, use
brake filler
and bleeder
unit VAS
5234
Install brake
pedal
depressor
VAG 1869/2
before
removing a
brake caliper
or
disconnecting
a brake hose.
1 - Hex
socket
head bolt,
80 Nm (59
ft. lb)
Rear wheel brakes/disc brakes (all-wheel drive), servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст