Volkswagen Golf / Golf GTI / Jetta. Manual — part 1188
91-57
On Board Diagnostic (OBD), function
CD Changer/Player functions are monitored by
applicable radio system OBD.
"Premium IV" and "Premium V" OBD
Page
01-1
"Premium VI" OBD
Page 91-27
.
CD Changer / CD Player
13/2/2005
91-58
CD Changer, removing and installing
Removal and installation described here is
essentially the same for both Golf and Jetta
models.
Notes:
When installing a new CD Changer in vehicle not
previously equipped with one:
Prior to installation, CD Changer position
(vertical or horizontal) must be set via the V/H
switches. Check and reset if necessary
91-60
.
Radio must be coded in order to support CD
Changer functions. After installing new CD unit,
input appropriate radio coding using On Board
Diagnostic program function 07, "Code Control
Module".
Removing
CAUTION!
Before beginning repairs on the electrical
system:
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
- Turn release knobs in direction of arrow and
open trim flap.
CD Changer / CD Player
13/2/2005
91-59
- Disconnect electrical connection
and unclip from retainer -arrow-.
Tightening torque: 3 Nm (27 in. lb.)
Installing
Note:
Radio sound system coding must be
performed to account for presence of
CD Changer, Monsoon amplifier (if
installed) and interior sound field
differences between models.
- Remove bolts -arrows- and
remove CD Changer from
retainer.
- Install in reverse order of removal.
- Ensure radio is coded accordingly
for CD Changer functions using
On Board Diagnostic program
function 07, "Code Control
Module": Radio system "Premium
IV" and "Premium V"
Page 01-
20
. Radio system "Premium VI"
Page 01-49
.
CD Changer / CD Player
13/2/2005
91-60
CD Changer position (V/H)
switches, setting
Notes:
- Check and confirm CD Changer
position settings via V/H switch
(or switches) -arrow- where
applicable.
- Loosen V/H switch retaining
screw, slide switch towards the
appropriate position according to
CD Changer's installation position
("V" = vertical, or "H" = horizontal)
and tighten.
Tightening torque: 3 Nm (27 in
lb)
CD playback will skip if switches
are not set correctly.
Always check/set switches prior
to CD installation.
Switches must move completely
to their end positions.
Before sliding CD Changer into
CD Changer bracket ensure that
the CD Changer cable and
conector route to the front side of
the CD Changer.
CD Changer / CD Player
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст