Volkswagen Golf / Golf GTI / Jetta. Manual — part 846
01-161
V.A.G 1551 display
Possible cause
Corrective action
01483
Activation of rear lid remote
unlocking
Undefined
switch position
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
01484
Central locking key button, lock
Short to
Ground
1)
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
01485
Central locking key button, unlock
Short to
Ground
1)
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
1)
DTC recorded if operated for longer than 10 seconds
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
01-162
Output Diagnostic Test Mode
(DTM), vehicles through 05.01
The components displayed in the Output
Diagnostic Test Mode (DTM) can differ
depending upon the equipment fitted to the
vehicle. For example on vehicles without
ATA there will be no step "1" as listed in the
table below.
The Output Diagnostic Test Mode (DTM)
activates the following components in the
stated sequence:
Step
Display in tester
Reaction
Alarm horn (for anti-theft alarm)
- Horn sounds continuously
Turn signal lights activation (for anti-
theft alarm)
- Activated continuously (lights up
cont.)
Interior light, reading lights
- Interior and reading lights are
activated
Signal close sliding roof
- Sliding roof closes
1)
"Safe" LED driver's door
- "Safe" LED lights up
Instrument illumination
- Switch illumination in control
module active
END
- Information: End of regular final
control test
1)
When performing Output Diagnostic Test Mode (DTM) "Signal close sliding roof", the
ignition and S-terminal must be inactive (no key in ignition/starter switch) and one of the
front doors must be open.
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
01-163
Special tools, testers and auxiliary items
V.A.G 1551 scan tool or vehicle V.A.G 1552
System tester with cable V.A.G 1551/3
V.A.G 1594 Adapter set
V.A.G 1527 LED test light
Wiring diagram
Work sequence
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-96
.
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Operate scan tool taking into account the
information on the display:
- Input 03 for "Output Diagnostic Test Mode
(DTM)" function.
- Switch off ignition and remove ignition key from
ignition lock.
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
01-164
Rapid data transfer
Q
03 Output Diagnostic Test Mode (DTM)
Indicated on display:
- Confirm entry with the -Q- button.
Final Control Diagnosis
Indicated on display:
Perform Output Diagnostice Test
Mode (DTM) by pressing button for
individual tests: See table on
Page 01-247
.
Output Diagnostic Test Mode (DTM)
can be terminated by pressing the -
C- button.
If a component does not function:
- Press
button.
- Continue Output Diagnostic Test
Mode (DTM) to the end.
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст