Volkswagen Golf / Golf GTI / Jetta. Manual — part 801
- Remove cover - 1 - with cushion - 3 -
from seat frame - 4 - .
- On underside of cushion, remove
staples - 2 - .
- Roll up cover until cushion wire can be
reached.
- Using a small screwdriver, unclip
cushion wire for cover out of frame - 5 - in
cushion.
- Remove cover from cushion.
- On inner side of left seat bolster, remove
staples - 6 - .
- Cut through all cushion clips - 5 - .
Note:
Front seat cushion and cover
13/2/2005
n
Cushion clips - 5 - are destroyed
upon removing, y must be replaced
during installation.
- Carefully remove seat bolster cover - 2 -
from cushion - 4 - .
- Carefully pull seat bolster cushion - 4 -
out of seat frame - 3 - .
Note:
n
same instructions apply to right seat
bolster cover - 1 - and
corresponding cushion.
Installing
- Installation is reverse of removal.
Front seat cushion and cover
13/2/2005
Front backrest cover and upholstery,
removing and installing
Note:
n
Slight changes may have to be made to removal and
installation procedures, depending upon equipment
installed in vehicle.
Removing
- Remove headrest.
- Remove seat
72-1, Front seats, removing and
installing
.
- Remove backrest
72-1, Front backrest, removing and
installing
.
- Unclip trim on rear side at bottom and
unhook upward.
Front seat cushion and cover
13/2/2005
- Separate beading strip - 1 - for cover - 2
- using a screwdriver - arrows - .
- Unhook tension wire - 1 - - arrows - .
- Remove adjusting knob - 1 - .
- Pull up cover - 1 - and remove from
tensioning frame - 2 - - arrows - .
- Pull cover - 1 - upward over cushion - 3 -
and headrest guides.
- Disconnect harness connector - 4 - for
backrest heater.
- Remove cushion - 3 - from backrest
frame - 5 - .
Note:
n
Upholstery - 3 - is secured to lumbar
Front seat cushion and cover
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст