Volkswagen Golf / Golf GTI / Jetta. Manual — part 294
34-84
Fig. 1
Driving out stop sleeve
Fig. 2
Driving stop sleeve in
onto stop
- Drive stop sleeve in onto stop
with 13 mm socket -A- and plastic
head hammer.
Transmission housing, servicing
34-85
Fig. 3
Driving out locking pin
Fig. 4
Driving in locking pin -
A- onto stop
Transmission housing, servicing
34-86
Fig. 5
Pulling out mounting
bushing for selector rod
A - Internal extractor 14.5 to 18.5
mm, e.g. Kukko 21/2
B - Counter support, e.g. Kukko
22/2
Fig. 6
Driving selector rod
mounting bushing in
flush
Transmission housing, servicing
34-87
A - Internal extractor 23.5 to 30.0
mm, e.g. Kukko 21/4
Note:
The needle bearing is destroyed
during removal and must be
replaced.
Fig. 7
Pulling reverse shaft
needle bearing out of
transmission housing
Counter support, e.g. Kukko 22/2
Fig. 8
Pressing needle bearing
-A- into transmission
housing
- By pressing in, lay reverse shaft
thrust washer -B- on needle
bearing.
- Support transmission housing
with tube VW 416 B directly below
bearing mounting.
Transmission housing, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст