Volkswagen Golf / Golf GTI / Jetta. Manual — part 892
01-344
Output Diagnostic Test Mode (DTM)
The components displayed in the Output
Diagnostic Test Mode (DTM) can differ
depending upon the equipment fitted to the
vehicle. For example on vehicles without
ATA there will be no step "1" as listed in the
table below.
The Output Diagnostic Test Mode (DTM)
activates the following components in the
stated sequence:
Step
Display in tester
Reaction
Alarm horn (for anti-theft alarm)
- Horn sounds continuously
Turn signal lights activation (for anti-
theft alarm)
- Activated continuously (lights up
cont.)
Interior light, reading lights
- Interior and reading lights are
activated
Close sliding roof signal
- Sliding roof closes
1)
"Safe" LED driver's door
- "Safe" LED lights up
Instrument illumination
- Instrument illumination activated
END
- Information: End of regular final
control test
1)
When performing final control test the "signal close sliding roof", the ignition and S-
terminal must be inactive (no key in ignition/starter switch) and one of the front doors
must be open.
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
01-345
Special tools, testers and auxiliary items
V.A.G 1551 scan tool or vehicle V.A.G 1552
System tester with cable V.A.G 1551/3
V.A.G 1594 Adapter set
V.A.G 1527 LED test light
Electrical wiring diagram
Work sequence
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-307
.
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Operate scan tool taking into account the
information on the display:
- Input 03 for "Output Diagnostic Test Mode
(DTM)" function.
- Switch off ignition and remove ignition key from
ignition lock.
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
01-346
Rapid data transfer
Q
03 Output Diagnostic Test Mode (DTM)
Indicated on display:
- Confirm entry with the -Q- button.
Output Diagnostic Test Mode (DTM)
Indicated on display:
Perform individual tests: See table
on
Page 01-344
.
Output Diagnostic Test Mode (DTM)
can be terminated by pressing the -
C- button.
If a component does not function:
- Press
button.
- Continue Output Diagnostic Test
Mode (DTM) to the end.
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
01-347
Read Measuring Value Block
Special tools, testers and auxiliary items
V.A.G 1551 Scan tool with V.A.G 1551/3
cable
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-307
.
The measured values in the functions Read
Measuring Value Block and basic setting are
described during the individual component test.
This table serves only as an overview.
The measured value block is divided into 10
display group numbers. The assignment of the
individual display zones can be taken from the
display group overview
Page 01-349
.
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- (08 initiates the "Read
Measuring Value Block" function).
Rapid data transfer
Q
08 Read Measuring Value Block
Indicated on display:
- Confirm entry with the -Q- button.
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст