Volkswagen Golf / Golf GTI / Jetta. Manual — part 493
19. Front control arm bushing
¡
Pressing out
40-3, Pressing
out front control arm bushing
¡
Pressing in
40-3, Pressing
in front control arm bushing
20. Hex bolt M 12 x 1.5 x 82
¡
70 Nm plus an additional
1
/
4
turn 90
¡
Always replace
21. Hex bolt, 50 Nm
¡
M10×70
22. Hex bolt, 50 Nm
¡
M10×30
23. Pendulum support
¡
Different versions
¡
Application
See Parts
Catalog
24. Hex bolt, 25 Nm
¡
M8×45
25. Rubber bushing
26. Clamp
27. Hex bolt, 25 Nm
28. Subframe
¡
If damaged, do not repair
threads in subframe for front
control arm bolt!
Front suspension, servicing
Modified mounting for stabilizer bar
Affected vehicles:
n
Vehicles with all wheel drive
1 - Nut, 90 Nm
2 - Control arm
3 - Hex bolt, 15 Nm plus an additional 1 / 4 turn 90
4 - Bracket
5 - Nut, 90 Nm
6 - Stabilizer bar
7 - Connecting Link
A - Upper threaded pin
- Install ball joint with long thread - A - at top on spring
plate.
B - Lower threaded pin
- Install ball joint with short thread - B - , at bottom on
stabilizer bar.
Ball joint, checking
Checking axial play
Front suspension, servicing
- Pull control arm down and press up again.
Check radial play
- Press lower part of wheel inward and outward.
Note:
n
There must be no perceptible or visual "play" when
carrying out both tests.
n
Observe ball joint during checks.
n
Take into account possible existing wheel bearing
play or "play" in upper suspension strut mount.
n
Check rubber boot for damage, replace ball joint if
necessary
Ball joint, removing and installing
Front suspension, servicing
Special tools, testers and auxiliary items
required
n
Hub puller 3283
n
Ball joint puller 3287 A
n
Engine/transmission jack V.A.G
1383 A
n
Angle wrench V.A.G1756
Removing
Note:
n
Vehicle must be standing on its wheels when
loosening or tightening 12-point axle nut
Front suspension, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст