Volkswagen Golf / Golf GTI / Jetta. Manual — part 481
47-66
Test step overview
To test component
Resistance of -V192- brake system vacuum pump
- Perform test
step 1
Communication signal of engine control unit to -V192- brake system
vacuum pump
- Perform test
step 2
Voltage supply of ignition/starter switch to -V192- brake system
vacuum pump
- Perform test
step 3
Resistance of connection of ignition/starter switch to -V192- brake
system vacuum pump
- Perform test
step 4
Resistance of connection of battery to -V192- brake system vacuum
pump
- Perform test
step 5
Voltage supply of Battery to -V192- brake system vacuum pump
- Perform test
step 6
Brake booster/brake master cylinder for vehicles with ABS/EDL/ASR/ESP Mark...
47-67
Test table (test steps 1 - 6)
Notes on test table
The socket designations of adapter VAG 1598/31 (for test step 2) are identical to the
engine control module contact designations in wiring diagram.
Electrical Wiring Diagrams, Troubleshooting & Component Locations binder
If the readings obtained deviate from the specifications, carry out repair measure in
the right-hand part of the table.
Electrical Wiring Diagrams, Troubleshooting & Component Locations binder
If the measured figures only deviate slightly from the specifications, clean sockets
and plugs of the testers and adapter cables (with contact spray G 000 700 04 ) and
repeat check. Before replacing components, check wiring and connections and also,
particularly for specifications of less than 10
, repeat resistance check on the
component.
Brake booster/brake master cylinder for vehicles with ABS/EDL/ASR/ESP Mark...
47-68
Switch to measuring range:
Resistance measurement (
)
Test
step
Contact
Item tested
Test
conditions
Specification Measures for
deviations from
specification
1
1 +
Ground
Resistance of -
V192- brake
system vacuum
pump
Ignition
switched
off
5.0...5.3
Electrical
Wiring Diagrams,
Troubleshooting
& Component
Locations binder
- Check wiring
using wiring
diagram
2
2 + pin
22
Communication
signal of engine
control unit to -
V192- brake
system vacuum
pump
Ignition
switched
off
0.0...0.1
Electrical
Wiring Diagrams,
Troubleshooting
& Component
Locations binder
- Check wiring
using wiring
diagram
Brake booster/brake master cylinder for vehicles with ABS/EDL/ASR/ESP Mark...
47-69
Switch to measuring range:
Voltage measurement (20 V =)
Test
step
Contact
Item tested
Test
conditions
Specification Measures for
deviations from
specification
3
3 + 1
Voltage supply
from
ignition/starter
switch to -V192-
brake system
vacuum pump
Ignition
switched
on
12.0...12.60 V
(approx.
battery
voltage)
Electrical
Wiring Diagrams,
Troubleshooting
& Component
Locations binder
- Check wiring
using wiring
diagram
Brake booster/brake master cylinder for vehicles with ABS/EDL/ASR/ESP Mark...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст