Volkswagen Golf / Golf GTI / Jetta. Manual — part 1192
91-72
Control module for multi-function
steering wheel -J453-, removing and
installing
Removing
CAUTION!
Before beginning repairs on the electrical
system:
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
- Remove lower footwell cover to gain access to
13 position relay carrier.
Installing
- Remove module -J453- position -5- and -
relay carrier -A-.
- Install in reverse order of removal.
- Coding multi-function steering wheel control
module
Page 01-74
Multi-function steering wheel
13/2/2005
91-73
Control module for multi-
function steering wheel multi-
pin connector assignments
1 - Comfort CAN Bus - Low
2 - Open
3 - Comfort CAN Bus - High
4 - Open
5 - Radio, serial data
6 - Data Link Connector (DLC) K-
wire
7 - Cruise Control System (CCS) -
resume, accelerate
8 - CAN Bus Ground (GND)
9 - Open
10 - Ground (GND), terminal 31
11 - Double tone horn relay
12 - Terminal15
13 - Terminal 30
14 - Open
15 - Terminal 58d
16 - Cruise Control System (CCS) +
(SET/ delay)
17 - Heating inlet "ON"
18 - CAN Bus to Control module in
steering wheel -E221-
Multi-function steering wheel
13/2/2005
91-74
Multi-function steering wheel
from 12.01, performing OBD
program functions using VAS
5051
OBD program text/data generated by
the multi-function steering wheel
control module in vehicles from
12.01 production may not be
recognized by VAG1551/1552 Scan
Tools (ST) with the latest program
card. For example: scan tool display
shows "text 799",
"01529 /references" or similar.
Only the VAS5051/5052 Vehicle
Diagnostic Testing and Information
System is capable of processing all
display text/data on these vehicles.
OBD program functions for multi-
function steering wheel must be
performed using the VAS5051
Vehicle Diagnostic Testing and
Information System in mode "Self
Diagnosis" or "Guided Fault
Finding".
Special tools, testers and auxiliary
items needed
VAS 5051 Vehicle Diagnostic
Testing and Information System
Cable adapter VAS 5051/1 or
VAS 5051/3
- Connect VAS 5051 with adapter
cable to Data Link Connector
(DLC) and select mode "Guided
Fault Finding"
- Enter appropriate model,
equipment and model year
information and press ">" to
confirm.
Multi-function steering wheel
13/2/2005
91-75
After all Control Modules have been registered
and DTC memories checked,
- Select "Go to"
- Select "Function / Component Selection"
- Select "Body (Repair Group 01; 27; 50 to 97"
- Select "Electrical System (Repair Group 27; 90
to 97)
- Select "01-Systems capable of self-diagnosis"
- Select "Multi-function steering wheel"
- Select "Multi-function steering wheel functions"
and press ">" to confirm
- Review displayed list of OBD program functions
and select as necessary, e.g.: "Multi-function
steering wheel, coding"
- Perform selected OBD program steps as
prompted by tester
Multi-function steering wheel
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст