Volkswagen Golf / Golf GTI / Jetta. Manual — part 710
determined.
To do so, using Scan Tool (ST) V.A.G1551 , check DTC
Memory of comfort system (address word 46)
.
Repair Manual, Body On Board Diagnostic (OBD),
Repair Group 01, Check DTC Memory
If there is an electrical fault via window regulator motor, this
can be removed from carrier assembly.
Removing
- Removing front door trim
.
Repair Manual, Body Interior, Repair Group 70, Door
trim
- Removing and installing lock cylinder housing
57-1,
Lock cylinder housing, removing and installing
.
- Pry off caps - 1 - .
- Lower door window until securing bolts of door window
are accessible.
Note:
Door windows
13/2/2005
If work step is not possible due to a malfunction via
electrical window regulator, window regulator motor can be
removed to be able to slide window down.
- Loosen bolts - 2 - and press clamping brackets apart.
- Slide door windows upward and secure (e.g. using
adhesive tape).
- Disconnect all connectors - arrows - .
- Remove bolts - 2 - .
Tightening torque: 20 Nm
Door windows
13/2/2005
- Remove bolts - arrows - . Remove upper carrier
assembly from door, lift and lift out from door toward hinge
side of door.
- Rotate carrier assembly and disconnect connector from
door lock.
- Then, unclip clips for electrical wires from rear side of
carrier assembly.
Installing
Door windows
13/2/2005
- Pull operating lever - 1 - in direction of -
arrow - .
- Using a screwdriver, tension spring - 2 -
secured to door lock in direction of -
arrow - and engage lock lever into
spring.
Note :
Lock is secured by engaging operating
lever. Thereby later "incorrect" clipping-in
of Bowden cable is prevented.
- Insert carrier assembly into door.
Door windows
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст