Volkswagen Golf / Golf GTI / Jetta. Manual — part 110
01-21
Indicated on display:
Select operating mode:
- Press button on screen for
"Vehicle self-diagnosis".
Indicated on display:
Select vehicle system:
- Press button "01 - Engine
electronics" on screen.
On Board Diagnostic (OBD)
01-22
The control module identification and
coding are shown on the display,
e.g.:
If the coding differs from the vehicle
version, then:
- Check control module coding
Page 24-177
, Coding Motronic
Engine Control Module (ECM) -
J220-.
Indicated on display:
Select diagnostic function:
At this point all diagnostic functions
are available.
- Press desired function on the
display.
- See repair procedures for further
measures.
On Board Diagnostic (OBD)
01-23
DTC memory
Check DTC memory of all control
modules
Page 01-27
, Automatic
test sequence.
DTC memory, checking and
erasing
Special tools, workshop
equipment, testers, measuring
instruments and auxiliary items
required
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with VAS
5051.
Test prerequisites
VAG 1551 scan tool (or VAG
1552 vehicle system tester) with
VAG 1551/3 adapter cable
The fuses must be OK.
DTC memory
01-24
Work sequence
Note:
Only when engine does not start:
- Operate starter for approx. 6
seconds. Then do not switch the
ignition off.
The main fuses must be OK.
The battery voltage must be at
least 11.5 V.
Ground (GND) connection
between engine and body must
be OK.
All electrical devices, e.g. lights
and rear window heating must
be turned off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
- Connect VAG 1551 scan tool (or
VAG 1552) and select Engine
Control Module (ECM) with the
"Address word" 01. When doing
this the engine must be running at
idle: (Connecting scan tool and
selecting Engine Control Module
(ECM)
Page 01-12
).
DTC memory
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст