Volkswagen Golf / Golf GTI / Jetta. Manual — part 543
- Compress coil spring until it can be removed.
- Stop clamping action, if spring coils touch themselves!
- Take spring with the spring compressor from vehicle.
If a shim is under stop buffer, you must take this out
together with spring.
- Place spring with spring compressor.
1 - Spring tensioner V.A.G1752/1
2 - Spring holder V.A.G1752/15L. O.
3 - Spring holder V.A.G1752/15L. U.
Installing left spring
- Install spring into spring holder.
The beginning of the spring coil must be positioned in
spring holder - arrow - , as represented.
I - Spring holder left bottom (L.U.)
II - Spring holder right bottom (L.U.)
- Turn spindle of the spring compressor until spring is
slightly tightened.
- Check whether spring holders rest correctly against spring
coils.
- Compress coil spring until it can be install into the vehicle.
- Stop clamping action, if spring coils touch themselves!
Rear axle, servicing (all wheel drive vehicles)
Installation position of spring
For vehicles without stop buffer - 2 - .
The beginning of spring coil - 3 - must be located in 9:00
o'clock position.
1 - Spring
2 - Bump stop
F - Driving direction
Installation position of spring
For vehicles with stop buffer - 2 - .
The end of coil spring must lie against stop - arrow - .
- Release tension of the spring by turning spindle clockwise.
- After releasing spring tension, check installation position
- Do not use an impact wrench or similar!
Rear axle, servicing (all wheel drive vehicles)
If you turn spindle too far, the spring holders block
themselves!
- Remove nut - 1 - off and remove screw with the spring
holder.
- Take spring compressor off spring.
Removing right spring
- Install the spring holder V.A.G1752/15R. U. to spring
compressor V.A.G1752/1
- Set spring holder V.A.G1752/15R. O. on highest spring
coil.
Rear axle, servicing (all wheel drive vehicles)
- Install spring compressor V.A.G1752/1 .
1 - Spring tensioner V.A.G1752/1
2 - Spring holder V.A.G1752/15R. U.
- Turn spindle of the spring compressor in a clockwise
direction so far, until the claws - arrows - of spring
compressor and spring holder interlock.
- Install bolt - 1 - at top of spring holder.
The bolt - 1 - must be put in from the bottom.
- Turn spindle of the spring compressor until spring is
slightly tightened.
- Check whether spring holders rest correctly against spring
coils.
Rear axle, servicing (all wheel drive vehicles)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст