Volkswagen Golf / Golf GTI / Jetta. Manual — part 123
01-71
DTC code
DTC text
Corrective action
SAE
VAG
P1196 17604 Bank 1 sensor 1,
heater element
circuit
Electrical
malfunction
- Check Oxygen Sensor (O2S) heating for
Oxygen Sensor (O2S) before Three Way
Catalytic Converter (TWC)
Page 24-38
P1198 17606 Bank 1 sensor 2,
heater element
circuit
Electrical
malfunction
- Check Oxygen Sensor (O2S) heating for
Oxygen Sensor (O2S) after Three Way
Catalytic Converter (TWC)
Page 24-45
DTC table: SAE P1 codes
01-72
Fuel and air measurements
DTC code
DTC text
Corrective action
SAE
VAG
P1250 17658 Fuel level too
low
1)
Fuel level in fuel tank less than 5 liter:
- Fill fuel tank
Repair Manual, Electrical Equipment On
Board Diagnostic (OBD), Repair Group 01
- Check signal from fuel gauge sensor:
P1296 17704 Malfunction in
cooling system
- Check Engine Coolant Temperature (ECT)
sensor
Page 24-69
Repair Manual, 2.8 Liter VR6 4V Engine
Mechanical, Engine Code(s): BDF,Repair Group
19
- Check thermostat:
1)
The DTC P1250 "Fuel level in fuel tank too low" is stored when there is insufficient fuel
in fuel tank or the DTC is stored permanently in the Motronic Engine Control Module
(ECM) -J220- and is not set to sporadic when the fuel tank is filled. Then attributed
Diagnostic Trouble Codes (DTCs) may have been detected due to insufficient fuel e.g.
misfire or Diagnostic Trouble Codes (DTCs) concerning the Oxygen Sensor (O2S).
DTC table: SAE P1 codes
01-73
Ignition system
DTC code
DTC text
Corrective action
SAE
VAG
P1325 17733 Knock control
cyl. 1
control limit
reached
- Check knock sensors
Page 28-30
P1326 17734 Knock control
cyl. 2
control limit
reached
- Repair abnormal engine running noises
(accessories loose, brackets/bolts broken)
P1327 17735 Knock control
cyl. 3
control limit
reached
- Loosen knock sensor and tighten again to 20 Nm
P1328 17736 Knock control
cyl. 4
control limit
reached
- Change type of fuel
P1329 17737 Knock control
cyl. 5
control limit
reached
P1330 17738 Knock control
cyl. 6
control limit
reached
DTC table: SAE P1 codes
01-74
DTC code
DTC text
Corrective action
SAE
VAG
P1335 17743 Engine torque monitor 2
Control limit exceeded
1)
- Check Intake Air Temperature (IAT)
sensor -G42-
Page 24-81
P1336 17744 Engine torque monitor
Control limit surpassed
- Check Mass Air Flow (MAF) Sensor
-G70-
Page 24-52
- Check Engine Coolant Temperature
(ECT) sensor -G62-
Page 24-69
P1337 17745 Bank 1, Camshaft Position
(CMP) Sensor -G40-
Short to Ground (GND)
- Check Camshaft Position (CMP)
Sensor -G40-
Page 28-16
P1338 17746 Bank 1, Camshaft Position
(CMP) Sensor -G40-
Open circuit/Short to positive
P1340 17748 Camshaft position/crankshaft
position sensor
Wrong allocation
- Check Camshaft Position (CMP)
Sensor -G40-
Page 28-16
P1347 17755 Bank 2, Camshaft
position/crankshaft position
sensor
Wrong allocation
- Check engine speed sensor
Page 24-93
Repair Manual, 2.8 Liter VR6 4V
Engine Mechanical, Engine Code(s):
BDF; Repair Group 15
- Check timing:
1)
If this malfunction occurs the Motronic Engine Control Module (ECM) -J220- switches
on the Electronic Power Control (EPC) Warning Light -K132- in the instrument cluster.
Significance of Electronic Power Control (EPC) Warning Light -K132-
Page 01-3
.
DTC table: SAE P1 codes
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст