Volkswagen Golf / Golf GTI / Jetta. Manual — part 423
45-74
- Release control module
connector (arrow -1-) and pull off
(arrow -2-).
- Release multi-pin connector cover
cap with a screwdriver and
remove.
ABS system components for front and rear axles, removing and installing
45-75
- Release secondary locking device
(violet) in direction of arrow with a
screwdriver.
ABS/EDS/ASR/ESP Mark 60
connector T47
Contact assignment of connector
T47 wiring harness/ABS control
module (w/EDL) -J104-.
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations binder
ABS system components for front and rear axles, removing and installing
45-76
- Push out relevant contacts with
an ejection tool from wiring
harness repair kit VAS 1978.
- Separate connector from speed
sensor wiring and speed sensor.
- For vehicles with brake wear
indicator separate connector -1-.
- Unclip the wiring from retainer -2-.
- Remove faulty speed sensor
wiring and guide in new speed
sensor wiring.
- Connect speed sensor to speed
sensor wiring.
ABS system components for front and rear axles, removing and installing
45-77
Make sure the wiring is not twisted
when installing the speed sensor
wiring in the wheel housing.
- Clip in speed sensor wiring
(arrows).
- Insert brake wear indicator
connector into bracket on
suspension strut.
- Guide contacts into connector
housing.
- Push individual wiring seals in
onto stop with an insertion tool
from VAS 1978.
- Secure contacts with secondary
locking device and install multi-pin
connector cover cap.
ABS system components for front and rear axles, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст