Volkswagen Golf / Golf GTI / Jetta. Manual — part 557
n
Tensioning strap T10038
n
Wheel hub support T10149
- Measure dimension - a - from center of wheel to lower
edge of wheelhouse.
- Make a note of the measurement. This is necessary to
tighten bolts for rear axle to bearing bracket.
Removing
Vehicles with automatic headlight range control
- Removing coupling rod from Left Rear Level Control
System Sensor G76 from rear axle
40-2, Left rear level
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
control system sensor G76 on rear axle for all wheel drive
.
Continue for all vehicles
- Remove wheel.
- Remove spring
Removing and installing spring
42-4, Spring, removing
and installing
.
Removing and installing spring R32
42-4, Spring R32,
removing and installing
- Unhook parking brake cable from brake calipers.
- Pull parking brake cable out of trailing arm.
- Remove drive axle
42-7, Rear drive axle, removing and
installing
.
- Unclip wire for wheel speed sensor from retainer - arrow -
.
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
- Disconnect ABS vehicle speed sensor from trail arm
housing.
- Remove brake line bracket from trailing arm.
- Unclip brake line from retainer - 1 - .
- Remove bolts - 1 - from brake caliper and remove brake
caliper.
- Secure brake caliper to body.
- Remove phillips-head screw for brake disc and remove
brake disc.
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
- Remove bolt - 2 - for transverse link.
3 - Upper transverse link
4 - Lower transverse link
5 - Trailing arm
- Position engine/transmission jack under trailing arm
- Remove shock absorber bolt.
- Mark installation position of bearing bracket on body.
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст