Volkswagen Golf / Golf GTI / Jetta. Manual — part 250
28-20
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Engine Control
Module (ECM) was disconnected from battery
positive, readiness code must be generated
again
Page 01-149
.
Checking sequence for Camshaft Position
(CMP) Sensor 2 -G163-
Note:
Mark connector and component before pulling
connector off.
- Disconnect 3-pin connector -2- from Camshaft
Position (CMP) Sensor 2 -G163-.
- Connect multimeter to measure voltage at
terminals 1 (positive) and 3 (Ground) of
Camshaft Position (CMP) Sensor connector
using adapter cables from V.A.G 1594.
- Switch on ignition.
Specification: at least 4.5 V
- Switch off ignition.
Ignition system, servicing
28-21
If no voltage is present:
- Remove wiper arms and cowl
panel:
Repair Manual, Electrical
Equipment; Repair Group 92
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM)
remains disconnected.
- Check wiring for open circuit
between test box and connector
referring to Electrical Wiring
Diagrams.
terminal 1 and socket 98
terminal 2 and socket 87
terminal 3 and socket 108
Wire resistance: max. 1.5
- Additionally check wires for short
to one another.
Specification:
Ignition system, servicing
28-22
If no wiring malfunction is detected and voltage
was present between terminals 1 and 3:
- Replace Camshaft Position (CMP) Sensor 2 -
G163-
Page 28-6
, item 13 .
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Engine Control
Module (ECM) was disconnected from battery
positive, readiness code must be generated
again
Page 01-149
.
If no wiring malfunction is detected and no
voltage was present between terminals 1 and 3:
- Replace Engine Control Module (ECM)
Page
24-173
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Engine Control
Module (ECM) again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Engine Control
Module (ECM) was disconnected from battery
positive, readiness code must be generated
again
Page 01-149
.
Ignition system, servicing
28-23
Ignition coil with power output stage,
checking
Note:
The ignition coils and power output stage are
combined into a single component and cannot be
replaced separately.
Special tools, materials and equipment
VAG 1526 or Fluke 83 Hand multimeter or VAG
1715 multimeter
VAG 1527 LED test light
VAG 1594 adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Ignition system, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст