Volkswagen Golf / Golf GTI / Jetta. Manual — part 916
01-1
On Board
Diagnostic
(OBD)
through
m.y. 2001
Tools
Special tools
and equipment
VAG 1551
Scan Tool
(ST)
`VAG
1551/3B
cable
VAS 5051
Vehicle
Diagnostic
Testing and
Information
System
On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
01-2
VAS 5051 or VAG 1551,
connecting
All functions previously performed
with the VAG 1551 or VAG 1552 can
also be performed using the VAS
5051 tester via operating mode
vehicle self-diagnosis.
Operating instructions for VAS
5051 tester.
VAS 5051, connecting
Test requirements:
All fuses OK according to wiring
diagram.
Battery voltage must be at least
11.5 volts.
Select operating mode, vehicle
system and function:
Display will indicate the control
module identification and the
coding.
Display will indicate all relevant
diagnostic functions.
- Connect VAS 5051/1 or VAS
5051/3 diagnostic wire to Data
Link Connector (DLC)
- Switch on ignition.
- Press "Vehicle Self-Diagnosis"
selection on display.
- Select the vehicle system to be
tested on display (touch screen).
- Select the desired function on
display.
On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
01-3
Notes:
Display fields in functions 04 (Basic setting) and
08 (Read Measuring Value Block) are listed
from top to bottom.
The following test sequences are described for
the VAG 1551 Scan Tool (ST).
VAG 1551, connecting
Test requirements:
All fuses OK according to wiring diagram.
Battery voltage must be at least 11.5 volts.
Notes:
Electrical Wiring Diagrams, Troubleshooting &
Component Locations
- Connect VAG 1551 Scan Tool (ST) with VAG
1551/3B cable to Data Link Connector (DLC).
If nothing is indicated on display, check voltage
supply for VAG 1551 scan tool according to
wiring diagram.
Depending on the program, additional operating
information can be printed out by pressing the
HELP button of the VAG 1551 scan tool.
Function 00 "Automatic test sequence" can be
performed in operating mode 1 "Rapid data
transfer". This automatically checks all control
modules installed in the vehicle.
The
button is used for advancing through
the program sequence.
The PRINT button is used for switching on the
printer (lamp in button lights up).
On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
01-4
VAG- On Board Diagnostic
HELP
1 - Rapid data transfer*
2 - Blink code output*
Indicated on display (* is displayed
alternately):
- Press button 1 for "Rapid data
transfer".
- Continue On Board Diagnostic
(OBD) of vehicle system to be
tested as described under
"performing On Board Diagnostic
(OBD)
table of contents
On Board Diagnostic (OBD) through m.y. 2001
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст