Volkswagen Golf / Golf GTI / Jetta. Manual — part 843
01-149
V.A.G 1551 display
Possible cause
Corrective action
01135
Interior monitoring sensors
Open circuit
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
- Read Measuring Value
Block; Display group
number 009
Page 01-
268
, display zone 4
Sensors for monitoring
interior not installed
- Check installation
Malfunctioning
Sensors for monitoring
interior malfunctioning
- Replace sensors for
monitoring interior
01141
Luggage compartment
unlocking switch -E165-
Implausible
signal
Faulty wiring or
connectors
Luggage compartment
unlocking switch -
E165- is
malfunctioning
- Check wiring and
connectors using wiring
diagram
- Replace luggage
compartment unlocking
switch -E165-
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
01-150
V.A.G 1551
display
Possible cause
Corrective action
01179
Incorrect key
programming
Matching of keys
(function 10) not
performed correctly
- See description for matching keys
with remote control,
Page 01-285
- Read Measuring Value Block;
Display group number 013
Page
01-277
, display zones 1 to 4
1)
1)
Number of keys matched ("learned") will be displayed.
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
01-151
V.A.G 1551
display
Possible cause
Corrective action
01328
Convenience
system data BUS
Faulty wiring or
connectors
Wiring OK., then:
Note: New DTC's are stored, these must
be erased
- Check wiring and connectors using
wiring diagram
- Disconnect all door main connectors
and reconnect one after the other while
observing measured value block
- Replace the control module that has
blocked the bus
- Read Measuring Value Block; Display
group number 012
Page 01-274
,
display zone 1
Control module
malfunctioning
- Replace relevant control module
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
01-152
V.A.G 1551 display
Possible cause
Corrective action
01329
Convenience system
data BUS in emergency
mode
Faulty wiring or
connectors
Wiring OK., then:
Note: New DTC's are stored, these
must be erased
- Check wiring and connectors using
wiring diagram
- Disconnect all door main connectors
and reconnect one after the other
while observing measured value block
- Replace the control module that has
blocked the bus
- Read Measuring Value Block;
Display group number 012
Page
01-274
, display zone 1
Convenience system (vehicles with power windows), On Board Diagnostic (OBD)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст