Volkswagen Golf / Golf GTI / Jetta. Manual — part 1206
4
Delivery inspection
⇒ Additional Information. Maintenance Schedule for
appropriate model year
Delivery inspection
13/2/2005
5
Maintenance service
⇒ Additional Information. Maintenance Schedule for
appropriate model year
Additional Information about GTI 337 Edition
Work to be completed
Page
Vehicle exterior
- Installing equipment which has been packed inside
vehicle (if part of original equipment): Mats, wiper arms,
spoilers, roof antenna, wheel trims/cover caps, tire valve
extensions.
01-6, Equipment which
has been packed inside
vehicle, installing
- Wheel securing bolts (lug nuts): Tighten to correct torque
setting
01-7, Wheel bolts, tighten
to correct torque setting
- Assembly tool for wheel trim: Place with vehicle tools
(only GTI 337 Edition)
01-7, Wheel bolts, tighten
to correct torque setting
Vehicle interior
- Telematics transport mode deactivation with VAS 5051
"Guided Fault Finding" and initialization of telematics
service
Maintenance service
13/2/2005
6
General
Engine compartment trim (sound insulation), removing and
installing
01-6, Engine compartment trim (sound
insulation), removing and installing
Type plate
01-6, Type plate
Diagnostic unit, connecting
01-6, Diagnostic scan tool,
connecting
Vehicle Identification Number (VIN)
01-6, Vehicle
Identification Number (VIN)
Vehicle data sticker
01-6, Vehicle data sticker
Engine code and engine number
01-6, Engine code and
engine number
Vehicle, lifting
01-6, Vehicle, lifting
Tow starting/towing
01-6, Tow starting/towing
Equipment which has been packed inside
vehicle, installing
Front valance spoiler (Jetta GLI)
- Before installing front valance, cut retaining plastic strap
on both sides of vehicle
General
13/2/2005
Installing front valance spoiler
1. Cover
2. Screw (Qty. 2). Torque specification: 2 Nm
3. Speed nut (Qty. 2)
4. Front valance spoiler. (Clipped to cover)
Warning!
When first installing front valance spoiler additional
bolts must be installed on both sides.
Install additional bolts at front valance spoiler (Jetta
GLI)
Note:
Additional screws must be installed on both sides of vehicle
when first installing front valance spoiler. This prevents
damage to front valance spoiler.
Following illustrations show right hand wheel housing liner.
Mounting on left hand wheel housing ls similar
Mounting - 1 - shown in illustration has already been done
in factory.
Material required
Speed nut (Qty. 2)
Self tapping screws (Qty. 2)
Additional bolts (rear view)
General
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст