Volkswagen Golf / Golf GTI / Jetta. Manual — part 1213

- Turn the adjusting button - 1 - clockwise.

With every brief turn of the adjusting button, the setting
changes by one minute. When turning and holding the
adjusting button, the setting continually adjusts.

With the adjusting button - 1 - the clock can be set to the
exact second:

- Turn the adjusting button to the right until the clock is one
minute less than the time that is to be set.

- Briefly turn the adjusting button to the right as soon as the
second indicator of the reference clock reaches the full
minute mark.

Climatronic, setting temperature to 72 F
(22 C)

Note:

A comfortable climate in vehicle is reached most quickly at
a temperature setting of 72 F (22 C)

Therefore, this setting should only be adjusted when it is
personally preferred.

- Switch ignition on

Description of work (part 1 of 2)

13/2/2005

- Check to see if 72 F (22 C) is set - 3 - in the display.

If necessary, perform the temperature setting as follows:

- Press button - 1 - for automatic operation. The display - 2
- will indicate AUTO.

- Adjust temperature to 72 F (22 C) by pressing button
- 4 - for "cooler" or button - 5 - for "warmer" .

Radio and radio/navigation system,
activating anti-theft coding

Radios and radio/navigation systems are delivered with a
security code. Security code means that every unit with
anti-theft coding is programmed with its own code. This
code is not active from factory.

Perform work sequence

- Refer to

Repair Manual, Communication, Repair Group 91,

Radio, Telephone, Navigation, Trip computer

Wheel cover caps

- Removing and installing wheel cover caps

Alloy wheel of Jetta GLI has a bolted wheel trim. You can
remove or install this using appropriate tool in vehicle.

Assembly tool for wheel trim is located in glove box.

Warning!

Do not use other assembly tools! Otherwise wheel trim
or alloy wheel can be damaged.

Description of work (part 1 of 2)

13/2/2005

Wheel bolts, tighten to correct torque
setting

Special tools, testers and auxiliary items required

Torque wrench V.A.G 1332/ (40 -200 Nm)

Wheel cover, removing

The removal hook is part of the vehicles tool kit

Wheel bolts

The adapter to loosen/tighten the anti-theft wheel bolts is
located with the vehicle tool kit.

Note:

Be sure to tighten wheel bolts one after the other to the
following specified torque:

Tightening torque: 120 Nm

After completion of work, return adapter and hook for wheel
cover to vehicle tool kit.

Full wheel cover, installing

Description of work (part 1 of 2)

13/2/2005

- Install full wheel cover with tire valve positioned in the cut-
out - arrow - .

Installation tool for wheel cover (Golf GTI 337 Edition)

- Place the wheel cover installation tool in the vehicle tool
kit, as shown in the illustration - arrow - .

Wheelhousing liner, bolting to front apron
(only anniversary Golf GTI with 132 kW
engine)

Note:

The wheel house lining must be fastened to the front apron
by an additional fixing bolt. This will help prevent damage
to the wheel house lining.

The following illustration shows the right wheel house
lining. The fastening of the left wheel house lining is the
same but reversed.

The fastening - 1 - in the illustration was performed by the
factory.

Necessary material:

2 x "N 015 439 1" spring nut

2 x "N 907 750 01" Torx socket head self-tapping screw
(4.8 x 16)

Work sequence for the additional fastener - 2 - :

Description of work (part 1 of 2)

13/2/2005