Volkswagen Golf / Golf GTI / Jetta. Manual — part 749
¡
5 Nm
5. Igniter
Side curtain protection, driver and
passenger sides, removing and installing
(Golf wagon/Jetta wagon)
Note:
n
Removal and installation is described for right side of
vehicle. same instructions apply for removal and
installation for left-hand side.
n
Observe notes regarding coding in radio operators
manual before disconnecting battery.
n
After connecting battery, vehicle options (radio, clock,
electric window regulator) must be checked according
to repair manual and/or user manual.
n
Technicians must electrostatically discharge mselves
by touching door lock or vehicle body briefly before
separating igniter and ground (GND) wires.
Removing
- Disconnect battery Ground (GND) strap
.
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
- Remove upper A pillar trim
70-3, Upper A-pillar trim,
removing and installing (Vehicles with side curtain
protection )
.
- Remove upper B-pillar trim
70-3, Upper B-pillar trim,
removing and installing (Vehicles with side curtain
protection 04.01)
.
- Remove upper C-pillar trim
70-3, Upper C-pillar trim,
removing and installing (Golf wagon/Jetta wagon with side
curtain protection 04.01)
.
- Removing D-pillar trim
70-3, Upper D-pillar trim,
removing and installing (Golf wagon/Jetta wagon)
.
Airbag
13/2/2005
- Molded headliner, removing
n
With sunroof
70-6, Molded headliner, removing and
installing (Vehicles with sunroof)
.
n
without sunroof
70-6, Molded headliner, removing
and installing (Vehicles without sunroof)
.
Caution!
Observe safety precautions for working on airbags
69-4, Safety precautions when working on airbags
.
Caution!
Electrostatic charges may result in
involuntary deployment of airbag.
Therefore, mechanic must be
electrostatically discharged before
disconnecting ignition- and Ground
(GND) wires. This is done e.g. by
briefly grasping chassis or door
striker.
- Disconnect harness connector - 3 - .
- Remove screws - 4 - (qty. 7, 5 Nm) and
pull out side curtain protection downward
out of angle brackets (hold catch - 2 - and
secure head-level airbag in angle
brackets).
Airbag
13/2/2005
- Remove side curtain protection without
bending from vehicle.
Installing
- Installation is reverse of removal.
- Switch on ignition.
- Close doors.
Caution!
Make sure no one is in vehicle.
- Connect battery Ground (GND) strap
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
Airbag
13/2/2005
.
Driver and front passenger seat side
airbags, assembly overview
1. Side airbag, driver with igniter for
side airbag -N199- or front
passenger with igniter for side
airbag -N200-
¡
Removing
69-4, Driver and
front passenger seat side
airbags, removing and
installing
2. Bolt
¡
Qty. 2
¡
7 Nm
Airbag
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст