Volkswagen Golf / Golf GTI / Jetta. Manual — part 404
noticed
26 - Bracket
Hydraulic unit, brake booster/master cylinder, overview
45-9
Brake lines from brake master
cylinder to hydraulic unit,
connecting
Fig. 1
Vehicles with ABS
A - Secondary piston circuit
B - Primary piston circuit
1 - Hydraulic unit to right front brake
caliper
2 - Hydraulic unit to left rear wheel
cylinder/brake caliper
3 - Hydraulic unit to right rear wheel
cylinder/brake caliper
4 - Hydraulic unit to left front brake
caliper
Fig. 2
Vehicles with ABS/EDL
A - Secondary piston circuit
B - Primary piston circuit
Hydraulic unit, brake booster/master cylinder, overview
45-10
Hydraulic
unit/ABS
control
module,
removing
and
installing
Special tools
and
equipment
VAG 1331
Torque
wrench or
equivalent
VAG 1410
Torque
wrench or
equivalent
VAG
1869/2
Brake
pedal
depressor
or
equivalent
Hydraulic unit, brake booster/master cylinder, overview
45-11
Additional required information
sources
Repair Manual, Brake System On
Board Diagnostic (OBD), Repair
Group 01
Component location:
The ABS control module is bolted
together with the hydraulic unit and
is located in the engine
compartment, left side.
CAUTION!
Brake lines in the area of the
hydraulic unit should not be bent!
Removing
- For vehicles with a coded radio,
obtain code.
- Disconnect battery
Repair Manual, Electrical
Equipment, Repair Group 27
- Disconnect electrical connector -
1- of Mass Air Flow MAF sensor
from air filter tube.
- Remove bolts -2- at air filter -3-
and move filter to left side.
- On vehicles with Diesel engines,
remove relay panel above brake
booster.
Hydraulic unit, brake booster/master cylinder, overview
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст