Volkswagen Golf / Golf GTI / Jetta. Manual — part 735
4. Spacer
5. Rear shelf
6. Rear shelf sheet metal
7. Washer nut
8. Rivet
n
Qty. 1
n
Removing and installing
n
Holes for anchorage points are
pre-drilled (3 locations) and
covered by rear shelf.
n
Locate predrilled holes and cut
material off in circular shape to
allow installation of anchorage
components.
n
With pre-drilled holes for
anchorage points.
n
Qty. 1
n
Install from below.
n
Two for washer nut - 7 - .
n
Install from below.
Seatbelts
13/2/2005
Illustration shows rear top ter strap attached to anchor in a
sedan model.
Rear top ter (Jetta Wagon)
Illustration shows approximate locations for rear top ter
anchorage points for Jetta Wagon.
Note:
n
Inside anchors are not recommended for attaching
rear lower anchors of a LATCH seat in middle
position. three-point lap/shoulder belt should be used.
Rear top ter (Golf)
Seatbelts
13/2/2005
Illustration shows approximate locations for rear top ter
anchorage points for Golf.
Note:
n
For MY 1999 vehicles only, rear top ters are not
installed in seatback. Vehicles for this model year may
require a seatback change for rear top ter installation.
Rear lower anchors (Golf)
Note:
n
Inside anchors are not recommended for attaching
rear lower anchors of a LATCH seat in middle
position. three-point lap/shoulder belt should be used.
Front belt tensioning unit, deploying
(disposal)
Caution!
n
It is dangerous to scrap an unignited gas
generator.
n
Belt tensioner unit gas generator must be made
unusable before scrapping. This is important
because gas generator is a pyrotechnic device
that can cause injury if activated improperly (for
instance when using a cutting torch).
- Remove seat belt with belt tensioning unit NO PAGE
Use Deployment Fixture J-44210 and refer to Airbag
Pyrotechnic Deployment Device Instruction Booklet for
proper deployment procedure.
Seatbelts
13/2/2005
69 - 2
Seatbelts, inspecting
Caution!
seatbelt system is to be systematically checked after
every accident! If damage has been found according to
check points, customer is to be notified of necessity of
a seatbelt replacement.
Check points
n
Check belt webbing
n
Check automatic retraction (locking effect)
n
Visual check of belt latch
n
Function check of belt latch
n
Checking guide stops and seatbelt lock tongue
n
Check anchoring components and anchoring points
n
Checking lap belt automatic retractor.
Note:
n
Make a note if customer refuses to allow replacement
of damaged seatbelt.
Belt webbing, checking
- Check belt webbing for soiling, wash with mild soap
solution if necessary.
⇒ Also refer to Owners Manual.
n
If one kind of damage (belt webbing cut, torn or
chafed) or (webbing loops on belt edge torn) shown in
following is detected on a vehicle which has been in
an accident, replace seatbelt complete with belt lock.
n
If one kind of damage described in following is
detected on a vehicle which has not been in an
accident, only damaged seatbelt needs to be
replaced.
Possible damage
Seatbelts, inspecting
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст