Volkswagen Golf / Golf GTI / Jetta. Manual — part 875
01-276
Evaluating display group number 012 - continued
Display
zone
Description
Display
Corrective action
3
Door control
module, rear lift
RL door = OK
Data reception from rear left
door control module via
convenience data bus OK
RL door 0= not OK
No data reception from rear
left door control module via
convenience data bus
If data bus reception
not OK
- Check data bus to
control module using
wiring diagram
4
Door control
module, rear
right
RR door = OK
Data reception from rear right
door control module via
convenience data bus OK
RR door 0= not OK
No data reception from rear
right door control module via
convenience data bus
Example:
For fault "Door control module (DCU), rear
left not answering" can be directly seen if
the DCU is connected.
For example, only "rr" is shown in display
zone 3.
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
01-277
Break down of display content for display group number 013
Display group 013 -Central control module-
Read measured value
block 13
Indicated on
display
xxx
xxx
xxx
xxx
1
2
3
4
Display zones
Specification
Evaluation
Empty
1)
Instrument illumination (in 16
steps, 0...100%)
mv (in 16
steps)
Page 01-
278
Rear, first detent
2)
open,
closed,
not installed
Rear lid button and rear lid handle
3,4)
not oper.
TG hndl op
implausible
1)
Empty means in this case: Display zone is blank
2)
Lock rotary latch must be engaged in first detent
3)
Rear lid remote opening button and rear lid handle
4)
Fault recorded if operated for longer than 10 seconds
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
01-278
Evaluating display group number 013
Display
zone
Description
Display
Corrective action
1
RLR button and
RL handle
1)2)
not
operated
RLR,
RL,
implausible
- Visual check of wiring
- Check that connections of relevant
current circuit are correctly connected and
seated securely while simultaneously
observing display
- If the display does not change when
operating, repair malfunction or replace
relevant component
- Erase DTC memory
- Perform functional check
- Check memory again
2
Rear, first detent
3)
open,
closed,
not
installed
3
Instrument
illumination
mv =
0...100%
(in 16
steps)
1)
Rear lid remote opening button and rear lid handle
2)
Fault recorded if operated for longer than 10 seconds
3)
Lock rotary latch must be engaged in first detent
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
01-279
Break down of display content for display group number 014
Display group 014 -Central control module-
Read measured value
block 14
Indicated on
display
xxx
xxx
xxx
xxx
1
2
3
4
Display zones
Specification
Evaluation
Key number
mv = display
0...4
0: not operated
Page 01-
280
Algorithm
OK.
not OK.
no measured
value
Code within effective range
OK.
not OK.
no measured
value
1)
Permanent code known
OK.
not OK.
no measured
value
1)
1)
If the remote control button is operated several times the third display - no measured
value - will change to "OK.".
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст