Volkswagen Golf / Golf GTI / Jetta. Manual — part 1072
27-31
CAUTION!
Before beginning repairs on the electrical
system
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
- Connect tester cable clamps to battery terminal
MCR 340V Instruction Manual Tester leads
must be securely fastened and make proper
contact with the battery posts.
Clamps must have a good contact with battery
terminals.
- Set tester to "Warranty Test"
MCR 340V
Instruction Manual.
- Perform battery battery test by setting load
current on tester according to battery (DIN)
capacity
MCR 340V Instruction Manual.
Note:
Use print function of MCR 340V where test
results are required for warranty claims.
Battery, checking
13/2/2005
27-32
Battery test results
Battery tester
display / print-
out
Required action
Good Battery
none
Good -
Recharge
Charge battery where
necessary
1)
Page 27-34
Use inCHARGE
Charge battery
1)
Page 27-34
Replace Battery
Replace battery
2)
Bad Cell -
Replace
Replace battery
2)
1)
Repeat battery battery test after recharging
battery.
2)
Replace battery with fastened fuse holder
Page 27-52
2)
Replace battery with clipped fuse holder
page 27-56
Battery, checking
13/2/2005
27-33
A battery is in good condition if the voltage
measured by the tester during the battery
test drops gradually and does not fall below
a specified value. The rate of decrease
varies and depends on the battery capacity
and cold cranking amp rating ("cold cranking
amps" is the rated ability of the battery to
perform at low temperatures and with high
loads i.e.: high compression engines).
A battery is either faulty or in a low state of
charge if the voltage measured during the
battery test drops quickly and falls below the
specified voltage.
After performing the battery test, a faulty
battery will remain below the specified
voltage and may only recover very slowly
over a long period of time. The no load
voltage (
Page 27-27
) is never reached.
Such batteries no longer have sufficient
reserve and load capacity and must be
replaced.
Battery, checking
13/2/2005
27-34
Battery, charging
WARNING!
Prior to handling or servicing batteries, read,
understand and observe the Warning and
Safety measures for lead-acid batteries
Page 27-4
.
Battery charger, connecting
WARNING!
Danger of explosion!
Batteries produce explosive gasses while
being charged.
Keep open flames and sparks away and DO
NOT smoke near batteries.
The battery charger MUST be turned off
when connecting or disconnecting the
cables at the battery.
Battery cell caps must NOT be removed
while charging.
"Boosting" a sulfated battery a high charging
rate can cause an explosion.
Ensure that battery is charged in a well
ventilated area.
Precision tools must not be kept in the same
room where batteries are being charged.
Tools may corrode due to chemical reaction.
Battery, charging
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст