Volkswagen Golf / Golf GTI / Jetta. Manual — part 547
The coil spring end must lie against stop - arrow - .
- Set spring with spring compressor V.A.G1752/1 .
- Screw lower bolt - arrow - to shock absorbers.
- Release spring tension by turning spindle clockwise.
- After releasing spring tension, check installation position
- Do not use an impact wrench or similar!
If you turn spindle too far, the spring holders block
themselves!
- Remove nut - 1 - off and remove screw with spring holder.
- Take spring compressor off spring.
Shock absorber, removing and installing
Special tools, testers and auxiliary items required
Rear axle, servicing (all wheel drive vehicles)
n
Torque wrench V.A.G1332
n
Engine/transmission jack V.A.G 1383 A with universal
transmission mount V.A.G1359/2
Removing
- First remove spring
Spring, removing and installing
42-4, Spring, removing
and installing
.
Removing and installing spring R32,
42-4, Spring R32,
removing and installing
- Remove wheel.
- Unclip wire for wheel speed sensor from retainer.
Rear axle, servicing (all wheel drive vehicles)
- Partially loosen wheel housing liner.
- Support rear axle with engine/transmission jack
V.A.G1383A .
- Remove shock absorber upper bolt - arrow - .
- Lower trailing arm slowly using engine/transmission jack
V.A.G1383A .
- Remove lower bolt - arrow - from shock absorbers.
- Remove absorber out of vehicle.
Installing
Rear axle, servicing (all wheel drive vehicles)
- Disconnect coupling rod from stabilizer bar - arrow - if
necessary.
This eases installation of the shock absorber lower
bolt.
Further installation in reverse order
Fastener/location
Tightening torques
Shock absorber to body
Use new bolts!
60 Nm
Shock absorber to trailing arm
110 Nm
Spring and shock absorbers on vehicles
with all-wheel drive, assembly overview
Rear axle, servicing (all wheel drive vehicles)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст