Volkswagen Golf / Golf GTI / Jetta. Manual — part 469
brake
cable
lever
replace
brake
caliper
housing
After
repairing,
pre-
bleed
caliper
housing
Page
47-26
Rear brake caliper, servicing
47-23
Rear brake caliper piston,
removing and installing
Special tools and equipment
3272 Piston resetting and removal
tool
3409 Wedge
Bleeder container
Rear brake caliper, servicing
47-24
Removing
Note:
- Remove piston out of brake
caliper housing by turning the
knurled wheel counter-clockwise.
Use special tool 3272/1 to help
screw in.
If piston is difficult to move, use a
13 mm (.512 in.) AF open end
wrench on the flats (arrow -A-)
provided for this purpose.
- Remove seal using wedge 3409.
Rear brake caliper, servicing
47-25
Installing
- The surface of the piston and seal must only be
cleaned with methylated spirits and then dried.
- Apply a thin coat of assembly lubricant G 052
150 A2 to piston and seal before inserting.
- Place protective seal with the outer sealing lip
on the piston.
Note:
Hold piston in front of caliper housing.
- Using wedge 3409, insert the inner sealing lip
into the grove in the cylinder.
Rear brake caliper, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст