Volkswagen Golf / Golf GTI / Jetta. Manual — part 99
26-34
Test sequence
- Test drive vehicle.
Observe the valid safety precautions when road
testing
Page 26-30
.
During the road test the following operating
conditions must be fulfilled:
The coolant temperature must exceed 85
C.
When the temperature is reached, the
operating conditions
Idling
Part throttle
Enrichment
Wide open throttle
Overrun
must be attained several times.
- Then:
Continue running engine at idling speed.
Secondary air system
26-35
- Connect V.A.G 1551 Scan Tool (or V.A.G 1552).
Start engine and select "Address word" 01 of
engine control module:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s) BDF, Repair Group
01
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press keys 0 and 4 for function "Initiate basic
setting" and confirm entry with Q key.
Basic setting
Input display group number XXX
Indicated on display:
- Press keys 0, 0 and 1 for "Display group number
1" and confirm entry with Q key.
System in basic setting 1
1
2
3
4
Indicated on display: (1...4
display zones)
Only continue with the test when:
Coolant temperature is above 85 C -Display
zone 2-
- Change to display group 77 as follows:
- Press C key.
Secondary air system
26-36
Basic setting
Input display group number XXX
Indicated on display
Note:
The engine must not be loaded
during this diagnosis, if this occurs
the diagnosis will be aborted and will
not start again until the engine is
revved-up.
- Press keys 0, 7 and 7 for "Display
group number 77" and confirm
entry with Q key.
System in basic setting 77
1
2
3
4
Indicated on display: (1...4
display
zones)
If the diagnosis is initiated by the
engine control module the display in
display zone 4 jumps from "Test
OFF" to "Test ON".
Note:
This process can take approx. 40
seconds.
If "Syst. OK" appears in display zone
4:
- Leave engine running at idling
speed until display zone 4
displays specification "Syst. OK."..
- Press
key.
Secondary air system
26-37
- Press keys 0 and 6 for function "End output" and
confirm entry with Q key.
- Switch ignition off.
If "Syst.n.OK." appears in display zone 4:
- Press
key.
- Check DTC memory:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s) BDF, Repair Group
01
- Read readiness code:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s) BDF, Repair Group
01
- Generate readiness code again if DTC memory
has been erased or engine control module
disconnected from permanent positive supply:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s) BDF, Repair Group
01
If no DTC is stored in DTC memory:
- Press keys 0 and 6 for function "End output" and
confirm entry with Q key.
- Switch ignition off.
- Check combi-valve
Page 26-41
.
Secondary air system
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст