Volkswagen Golf / Golf GTI / Jetta. Manual — part 132
01-107
If the solenoid valve does not click:
- Disconnect 2-pin connector from
Evaporative Emission (EVAP)
Canister Purge Regulator Valve -
N80- (arrow).
LED flashes:
- Connect LED test light VAG 1527
to disconnected connector using
adapter cables from VAG 1594.
LED must flash (bright/darker)
- Press -C- button to abort output
Diagnosis Test Mode (DTM).
Output Diagnosis Test Mode (DTM)
01-108
Output Diagnosis Test Mode was aborted
Indicated on display:
LED does not flash:
- Switch off ignition.
- Replace Evaporative Emission
(EVAP) Canister Purge
RegulatorValve -N80-.
- Check DTC memory, repair
Diagnostic Trouble Codes (DTCs)
if necessary and then erase DTC
memory
Page 01-23
, DTC
memory, checking and erasing.
- Read readiness code
Page 01-
146
. If the DTC memory has
been erased or the Motronic
Engine Control Module (ECM) -
J220- was disconnected from
battery (B+) positive, the
readiness code must be
generated again
Page 01-149
.
- Press -C- button to abort output
Diagnosis Test Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
Repair Manual, Electrical
Equipment; Repair Group 92
- Switch off ignition.
- Remove wiper arms and cowl
panel:
Output Diagnosis Test Mode (DTM)
01-109
- Connect test box VAG 1598/31 to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
If no wiring malfunction is found:
- Check wire for open circuit
between test box socket 64 and
2-pin connector terminal 2
referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
- Additionally check wire for short
to battery positive and Ground
(GND).
Specification:
- Check wire for open circuit
between 2-pin connector terminal
1 and Fuel Pump (FP) relay -J17-
referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
- Replace Motronic Engine Control
Module (ECM) -J220-
Page 24-
173
.
Output Diagnosis Test Mode (DTM)
01-110
- Check DTC memory, repair Diagnostic Trouble
Codes (DTCs) if necessary and then erase DTC
memory
Page 01-23
, DTC memory, checking
and erasing.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If the
DTC memory has been erased or the Motronic
Engine Control Module (ECM) -J220- was
disconnected from battery (B+) positive, the
readiness code must be generated again
Page 01-149
.
2. Activating Secondary Air Injection (AIR)
Solenoid Valve -N112-:
- Press
button.
Output Diagnosis Test Mode (DTM)
Secondary Air Injection Solenoid Valve
Indicated on display:
The Secondary Air Injection (AIR) Solenoid
Valve must click, until the next final control
element is activated by pressing
button.
Output Diagnosis Test Mode (DTM)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст