Volkswagen Golf / Golf GTI / Jetta. Manual — part 1176
91-11
20 pin multi-connector I -T20-, part
3, blue
8 pin multi-connector II -T8a-,
brown
13 - CD Changer - DATA IN
14 - CD Changer - DATA OUT
15 - CD Changer - CLOCK
16 - CD Changer - Power supply,
positive (B+) supply
17 - CD Changer - Control signal
18 - CD Changer - Ground (GND),
terminal 31
19 - CD Changer - LINE OUT, left
20 - CD Changer - LINE OUT, right
1 - Speaker + right rear
2 - Speaker - right rear
3 - Speaker + right front
4 - Speaker - right front
5 - Speaker + left front
6 - Speaker - left front
7 - Speaker + left rear
8 - Speaker - left rear
Radio, Premium IV'
13/2/2005
91-12
8 pin multi-connector III -T8-,
black
1 - Signal for anti-theft alarm
system
2 - Open
3 - Data Link Connector (DLC) K-
wire
4 - Ignition switch - S contact
5 - Battery, positive (B+) supply,
terminal 30 (control input for
"SAFE" display/anti-theft)
6 - Illumination, terminal 58b
7 - Battery, positive (B+) supply,
terminal 30
8 - Battery, negative (-) ground
supply, terminal 31
Radio, Premium IV'
13/2/2005
91-13
Anti-theft security code, inputting
The security code is "fixed", meaning the radio is
programmed by the radio manufacturer to accept
only one code. This code must be input during
the new vehicle delivery inspection, into newly
installed or existing units that have been
removed and reinstalled.
Prerequisites:
Obtain security code, either from code card or
from customer.
Radio power supply fuse OK (according to
wiring diagram)
Inputting code / cancelling electronic lock-up
- Switch on radio
"SAFE" appears in radio display, followed by
"1000" approximately 3 seconds later.
- Input the security code found on the radio card
using the station preset buttons on the radio.
Button "1" corresponds to the first number in the
security code, "2" the second and so on. Press
the applicable button repeatedly until the desired
number appears in the display (E.g.: press
button "1" three times if the first number in the
code is 3).
- When the entire code has been input and
appears on the display, press the right side of
the "Seek" button ("
") for longer than 2
seconds until an audible signal is heard.
Radio, Premium IV'
13/2/2005
91-14
Incorrect code number
If an incorrect code is entered, "SAFE" will
appear in the display (first blinking and then
continuous) and the radio will not function.
The entire coding procedure can only be
repeated one more time immediately (the
number of attempts is displayed).
If during the second attempt an incorrect
code is entered, the radio will lock-up for
approximately one hour. Leave key in
ignition, radio switched on for 1 hour and
attempt coding again when the number of
attempts on display goes out (ensure proper
code is available).
Cycle: 2 attempts - 1 hour lock-up still
applies.
Radio, Premium IV'
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст