Volkswagen Golf / Golf GTI / Jetta. Manual — part 270
20 Nm
Loosen
and
tighten
gradually
and
diagonally
Clutch, servicing
30-28
Note:
Pressure plate contact surface and
clutch plate must make full contact
with flywheel. Tighten bolts
diagonally and evenly to prevent
damage to the centering holes in the
pressure plate housing and the
centering pins in the flywheel.
Fig. 1
Centering clutch plate
with larger hub diameter
and removing and
installing pressure plate
- Loosen and tighten bolts
gradually and diagonally.
- Reverse position of retainer 3067
when removing.
Wear up to half the thickness of the
diaphragm spring is permitted.
Fig. 2
Checking ends of
diaphragm spring
Clutch, servicing
34-1
Gear
selector
mechanism,
servicing
Installed
position of gear
selector
mechanism
Arrow -A- Gear
selection
movement
Arrow -B- Gate
selection
movement
A - Gear
change
cable
B - Gate
selector
cable
C - Heat
shield
Remove
before
removing
the gear
selector
mechanism.
1 - Gear
selector
lever
2 - Relay lever
Gear selector mechanism, servicing
34-2
Removing and
installing selector
mechanism
Page 34-15
Adjusting
selector
mechanism
Page 34-22
Note:
I -
Removing
and
installing
shift knob
and cover
Page
34-4
II -
Servicing
shift
lever and
shift
housing
Page
34-6
III -
Assembly
overview:
Removing
and
installing
operating
cables
Page 34-
10
Before
working on
the selector
mechanism,
disconnect
Ground strap
from the
battery in the
engine
compartment.
Gear selector mechanism, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст